PQ60120EGL07 Datasheet, PDF (7/13 Pages) SynQor Worldwide Headquarters – Eighth-brick DC/DC Converter

Technical Specification
Input: 35-75 V
Output: 12 V
Current: 6.25 A
Package: Eighth-brick
See Fig. 15
10 µH
source
impedance
See Fig. 14
See Fig. 16
i_S
V_SOURCE
i_C
47 µF,
<1W ESR
electrolytic
capacitor
DC/DC
Converter
V_OUT
1 µF 10 µF,
ceramic _{100mW ESR}
capacitor _tantalum
capacitor
Figure 13: Test set-up diagram showing measurement points for Input
Terminal Ripple Current (Figure 14), Input Reflected Ripple Current
(Figure 15) and Output Voltage Ripple (Figure 16).
Figure 14: Input Terminal Ripple Current, ic, at full rated output cur-
rent and nominal input voltage with 10µ H source impedance and 47µ F
electrolytic capacitor (200 mA/div). See Figure 13.
Figure 15: Input reflected ripple current, is, through a 10 µ H source
inductor at nominal input voltage and rated load current (10 mA/div).
See Figure 13.
Figure 16: Output voltage ripple at nominal input voltage and rated
load current (10 mV/div). Load capacitance: 1µ F ceramic capacitor
and 10µ F tantalum capacitor. Bandwidth: 20 MHz. See Figure 13.
14
13
12
11
10
35 Vin
9
48 Vin
75 Vin
8
0
1
2
3
4
5
6
7
8
Load Current (A)
Figure 17: Output voltage vs. load current showing typical current limit
curves and converter shutdown points.
Figure 18: Load current (5A/div) as a function of time when the con-
verter attempts to turn on into a 10 mW short circuit. Top trace
(2.0ms/div) is an expansion of the on-time portion of the bottom trace.
Product # PQ60120EGL07
Phone [phone]
www.synqor.com
Doc.# 005-2EG612D Rev. B
8/23/07
Page 7