PQ60120HZA50 Datasheet, PDF (3/13 Pages) SynQor Worldwide Headquarters – Half-brick DC/DC Converter

Technical Specification
Input: 35-75 V
Output: 12 V
Current: 50 A (600W)
Package: Half-brick
MECHANICAL
DIAGRAM
(base-plated)
1.000
(25.40)
0.700
(17.78) _0.400
(10.16)
1.400
(35.56)
2.00
(50.8)
2.40
(61.0)
0.20
(5.1)
Side View
0.495 +0.024
(12.57 +0.6)
Overall height
0.044 +0.027
(1.12 +0.68)
Bottom side
Clearance
Load Board
Flanged Pin
See Note 12
0.145 typ.
(3.68)
See Note 6
2.30
(58.4)
1.90
(48.3)
0.19
(4.8)
9 876
Top View
12
3
1.000
(25.40)
1.400
(35.56)
5
0.20
(5.1)
1.90
(48.3)
4
0.400
(10.16)
0.50
(12.6)
M3
Threaded
Standoff
4 Places
See Note 1
NOTES
1) M3 screws used to bolt unit’s baseplate to other surfaces (such
as heatsink) must not exceed 0.100” (2.54 mm) depth below
the surface of the baseplate.
2) Applied torque per screw should not exceed 6in-lb. (0.7 Nm)
3) Baseplate flatness tolerance is 0.004” (.10mm) TIR for surface
4) Pins 1, 2, 4, 6-8, are 0.040” (1.02mm) diameter with 0.080”
(2.03mm) diameter standoff shoulders
5) Pins 5, 9 are 0.080” (2.03mm) diameter shoulderless pins.
6) Other pin extension lengths available
7) All Pins: Material - Copper Alloy
Finish - Matte Tin over Nickel plate
8) Undimensioned components are shown for visual reference only.
9) Weight: 4.3 oz. (123 g) typical
10) All dimensions in inches (mm)
Tolerances: x.xx +/-0.02 in. (x.x +/-0.5mm)
x.xxx +/-0.010 in. (x.xx +/-0.25mm)
11) Workmanship: Meets or exceeds IPC-A-610C Class II
12) The flanged pins are designed to permit surface mount
soldering (allowing to avoid the wave soldering process) through
the use of the flanged pin-in-paste technique.
PIN DESIGNATIONS
Pin connections are identical to open frame version
shown on page 2. Use “B” as 10th letter in part
number for base-plated version (see ordering page).
Product # PQ60120HZA50
Phone [phone]
www.synqor.com
Doc.# 005-2HZ612J Rev. A
8/20/07
Page 3