PQ60120QEA17 Datasheet, PDF (2/14 Pages) SynQor Worldwide Headquarters – Quarter-brick DC-DC Converter

Technical Specification
MECHANICAL DIAGRAM (open frame)
2.30
(58.4)
0.14
(3.6)
0.43
(10.9)
2.00
(50.8)
Top View
1.45
0.300
(36.8)
(7.62)
0.600
(15.24)
Input: 35-75 V
Output: 12 V
Current: 17 A (200W)
Package: Quarter-brick
0.300
0.150 ^(7.62)
(3.81)
0.450
(11.43)
0.600
(15.24)
Side View
Bottom side
Clearance
See Note 9
0.025 +0.024
(0.64 +0.61)
Lowest
Component
Load Board
Flanged Pin
See Note 10
0.436 max
(11.06)
0.180
(4.57)
See Note 3
NOTES
1) Pins 1-3, 5-7 are 0.040” (1.02mm) diameter with
0.080” (2.03 mm) diameter standoff shoulders.
2) Pins 4 and 8 are 0.062” (1.57 mm) diameter with 0.100”
(2.54 mm) diameter standoff shoulders.
3)Other pin extension lengths available.Recommended pin
length is 0.03” (0.76mm) greater than the PCB thickness.
4) All Pins: Material - Copper Alloy
Finish (RoHS 5/6) - Tin/Lead over Nickel plate
Finish (RoHS 6/6) - Matte Tin over Nickel plate
5) Undimensioned components are shown for visual reference only.
6) All dimensions in inches (mm)
Tolerances: x.xx+0.02 in. (x.x+0.5mm)
x.xxx+0.010 in. (x.xx+0.25mm)
7) Weight: 1.5 oz. (42 g) typical
8) Workmanship: Meets or exceeds IPC-A-610C Class II
9) UL/TUV standards require a clearance greater than 0.04” (1.02mm) between input and
output for basic insulation. This issue should be considered if any copper traces are on
the top side of the user’s board. Note that the ferrite cores are considered part of the
input/primary circuit.
10) The flanged pins are designed to permit surface mount soldering (allowing to avoid the
wave soldering process) through the use of the flanged pin-in-paste technique.
PIN DESIGNATIONS
PIN NAME FUNCTION
1 Vin(+) Positive input voltage
2 ON/OFF TTL input to turn
converter on and off,
referenced to Vin(–),
with internal pull up.
3 Vin(–) Negative input voltage
4 Vout(–) Negative output voltage
5 SENSE(–) Negative remote sense1
6 TRIM
Output voltage trim2
7 SENSE(+) Positive remote sense3
8 Vout(+) Positive remote sense3
Notes:
1. SENSE(–) should be connected to Vout(–)
either remotely or at the converter.
2. Leave TRIM pin open for nominal output
voltage.
3. SENSE(+) should be connected to
Vout(+) either remotely or at the
converter.
Product # PQ60120QEA17
Phone [phone]
www.synqor.com
Doc.# 005-0005068 Rev. A
03/19/09
Page 2