|
PQ60280FTA26 Datasheet, PDF (13/14 Pages) SynQor Worldwide Headquarters – Full-brick DC/DC Converter | |||
|
◁ |
Technical Specification
Input: 36-75 V
Output: 28 V
Current: 26 A
Package: Full-brick
APPLICATION CONSIDERATIONS
Input System Instability: This condition can occur because
any DC/DC converter appears incrementally as a negative
resistance load. A detailed application note titled âInput
System Instabilityâ is available on the SynQor website which
provides an understanding of why this instability arises, and
shows the preferred solution for correcting it.
Application Circuits: Figure D below provides a typical cir-
cuit diagram which details the input filtering and voltage trim-
ming.
Input Filtering and External Input Capacitance: This fil-
ter dramatically reduces input terminal ripple current, which oth-
erwise could exceed the rating of an external electrolytic input
capacitor. The recommended external input capacitance is spec-
ified in the âInput Characteristicsâ section. More detailed infor-
mation is available in the application note titled âEMI
Characteristicsâ on the SynQor website.
Output Filtering and External Output Capacitance:
Figure E below shows the internal output filter components. This
filter dramatically reduces output voltage ripple. However, some
minimum external output capacitance is required, as specified in
the Output Characteristics section on the Electrical Specifications
page. No damage will occur without this capacitor connected,
but peak output voltage ripple will be much higher.
RoHS Compliance: The EU led RoHS (Restriction of Hazardous
Substances) Directive bans the use of Lead, Cadmium,
Hexavalent Chromium, Mercury, Polybrominated Biphenyls
(PBB), and Polybrominated Diphenyl Ether (PBDE) in Electrical
and Electronic Equipment. This SynQor product is available as
6/6 RoHS compliant. For more information please refer to
SynQorâs RoHS addendum available at our RoHS Compliance /
Lead Free Initiative web page or e-mail us at rohs@synqor.com.
2 x 4.7µF
local ceramic
Vin(+)
Vout(+)
Electrolytic
Capacitor
Vsense(+)
Vin
External
Input
100µF
ESR @0.2W
ON/OFF
Trim
Rtrim-up
or
Filter
Vsense(_)
Rtrim-down Cload
Iload
Vin(_)
Vout(_)
Figure D: Typical application circuit (negative logic unit, permanently enabled).
Product # PQ60280FTA26
Phone 1-888-567-9596
www.synqor.com
Doc.# 005-2FT628P Rev. C
5/21/08
Page 13
|
▷ |