SM5964_06 Datasheet, PDF (14/26 Pages) SyncMOS Technologies,Inc – 8-Bits Micro-controller 64KB ISP flash & 1KB RAM embedded

SyncMOS Technologies International, Inc.
SM5964
8-Bits Micro-controller
64KB ISP flash & 1KB RAM embedded
5. Reduce EMI Function
The SM5964 allows user to reduce the EMI emission by setting 1 to the bit 0 (ALEI) of SCONF register. This function
will inhibit the clock signal in Fosc/6Hz output to the ALE pin.
6. Specific Pulse Width Modulation (SPWM)
The Specific Pulse Width Modulation (SPWM) module has five 8-bit channels, each channel contains a 8-bit wide
SPWM data register (SPWMD) to decide number of continuous pulses within a SPWM frame cycle.
6.1 SPWM Function Description:
Each 8-bit SPWM channel is composed of an 8-bit register which contains a 5-bit SPWM in MSB portion and a 3-bit
binary rate multiplier (BRM) in LSB portion. The value programmed in the 5-bit SPWM portion will determine the pulse
length of the output. The 3-bit BRM portion will generate and insert certain narrow pulses among an 8-SPWM-cycle
frame. The number of pulses generated is equal to the number programmed in the 3-bit BRM portion. The usage of the
BRM is to generate equivalent 8-bit resolution SPWM type DAC with reasonably high repetition rate through 5-bit
SPWM clock speed. The PDIV[1:0] settings of SPWMC ($A3) register are dividend of Fosc to be SPWM clock,
Fosc/2^(PDIV[1:0]+1). The SPWM output cycle frame repetition rate (frequency) equals (SPWM clock)/32 which is
[Fosc/2^(PDIV[1:0]+1)]/32.
6.2 SPWM Registers - P1CON, SPWMC, SPWMR[4:0]
SPWM Registers - Port1 Configuration Register (P1CON, $9B)
Read / Write:
Reset value:
bit-7
SPWM4E
R/W
0
SPWM3E
R/W
0
SPWM2E SPWM1E SPWM0E
R/W
R/W
R/W
0
0
0
Unused
-
*
Unused
-
*
bit-0
Unused
-
*
SPWM[4:0]E :When the bit set to one, the corresponding SPWM pin is active as SPWM function. When the bit reset to
zero, the corresponding SPWM pin is active as I/O pin. Five bits are cleared upon reset.
SPWM Registers -SPWM Control Register (SPWMC, $A3)
bit-7
bit-0
Read / Write:
Reset value:
Unused
-
*
Unused
-
*
Unused
-
*
Unused
-
*
Unused
-
*
Unused
-
*
PDIV1
R/W
0
PDIV0
R/W
0
PDIV[1:0] : These two bits is 2’s power parameter to form a frequency divider for input clock.
Specifications subject to change without notice contact your sales representatives for the most recent information.
Ver 2.2 SM5964 08/2006
14