S9418 Datasheet, PDF (6/10 Pages) Summit Microelectronics, Inc. – Quad 8-Bit Nonvolatile DACPOT™ Electronic Potentiometer With a Mute Control Input

S9418
ABSOLUTE MAXIMUM RATINGS
VDD to GND ................................................................... -0.5V to +7V
Digital Inputs to Gnd ............................................. -0.5V to VDD+0.5V
Analog Inputs to ground ........................................ -0.5V to VDD+0.5V
Digital Outputs to Gnd ........................................... -0.5V to VDD+0.5V
Analog Outputs to Gnd ......................................... -0.5V to VDD+0.5V
Temperature Under Bias ........................................... -55°C to +125°C
Storage Temperature ................................................ -65°C to +150°C
Lead Soldering (10 Sec Max) ................................................... 300°C
Stresses listed under Absolute Maximum Ratings may cause perma-
nent damage to the device. These are stress ratings only, and functional
operation of the device at these or any other conditions outside those
listed in the operational sections of this specification is not implied.
Exposure to any absolute maximum rating for extended periods may
affect device performance and reliability.
RECOMMENDED OPERATING CONDITIONS
Condition
Temperature
VDD
Min
-40°C
+2.7V
Max
+85°C
+5.5V
2023 PGM T2 1.1
RELIABILITY CHARACTERISTICS (over recommended operating conditions unless otherwise specified)
Symbol Parameter
Min
Max
Unit
Test Method
VZAP
ILTH
TDR
NEND
ESD Susceptibility
Latch-Up
Data Retention
Endurance
2000
100
100
1,000,000
V
mA
Years
Stores
MS-883, TM 3015
JEDEC Standard 17
MS-883, TM 1008
MS-883, TM 1033
2023 PGM T3 1.1
DC ELECTRICAL CHARACTERISTICS (over recommended operating conditions unless otherwise specified)
Symbol
Parameter
Conditions
Min
Max
Units
IDD
Supply Current
during store, note 1
CS = VIL
I_SB
Standby Supply Current
CS = V_IH
IIH
Input Leakage Current
VIN = VDD
IIL
Input Leakage Current
VIN =0V
V_IH
High Level Input Voltage
VIL
Low Level Input Voltage
VOH
High Level Output Voltage
IOH = -400µA
V_OL
Low Level Output
Voltage
I_OL=1mA, V_DD = +5V
I_OL= 0.4mA, V_DD = +2.7V
Note 1: IDD is the supply current drawn while the EEPROM is being updated
1.8
mA
2
0
VDD-0.3
0.4
800
10
-10
V_DD
0.8
0.4
V
µA
µA
µA
V
V
V
V
2023 PGM T4 1.2
2023 1.5 4/24/99
6