STM32F101RBH6 Datasheet, PDF (87/90 Pages) STMicroelectronics – Medium-density access line, ARM-based 32-bit MCU with 64 or 128 KB Flash, 6 timers, ADC and 7 communication interfaces

STM32F101x8, STM32F101xB
Revision history
Table 54. Document revision history (continued)
Date
Revision
Changes
21-Jul-2008
Small text changes.
Power supply supervisor on page 16 modified and V_DDA added to Table 8:
General operating conditions on page 33.
Capacitance modified in Figure 11: Power supply scheme on page 31.
Table notes revised in Section 5: Electrical characteristics.
Maximum value of t_RSTTEMPO modified in Table 10: Embedded reset and
power control block characteristics on page 35.
Values added to Table 15: Typical and maximum current consumptions in
Stop and Standby modes and Table 21: Typical current consumption in
Standby mode removed.
f_{HSE_ext} modified in Table 19: High-speed external user clock
characteristics on page 45. f_{PLL_IN} modified in Table 26: PLL
characteristics on page 50.
8
f_HCLK corrected in Table 29: EMS characteristics.
Minimum SDA and SCL fall time value for Fast mode removed from
Table 39: I2C characteristics on page 63, note 1 modified.
t_h(NSS) modified in Table 41: SPI characteristics on page 65 and
Figure 30: SPI timing diagram - slave mode and CPHA = 0 on page 66.
C_ADC modified in Table 42: ADC characteristics on page 68 and
Figure 34: Typical connection diagram using the ADC modified.
f_PCLK2 corrected in Table 44: ADC accuracy - limited test conditions and
Table 45: ADC accuracy.
Typical T_{S_temp} value removed from Table 46: TS characteristics on
page 72.
LQFP48 package specifications updated (see Table 51, Table 45 and
Table 46).
Axx option removed from Table 53: Ordering information scheme on
page 82.
24-Jul-2008
9
First page modified: “Up to 2 x I²C interfaces” instead of “1 x I²C interface”
STM32F101xx devices with 32 Kbyte Flash memory capacity removed,
document updated accordingly.
Section 2.2: Full compatibility throughout the family on page 14 updated.
Notes modified in Table 4: Medium-density STM32F101xx pin definitions
on page 24.
Note 2 modified below Table 5: Voltage characteristics on page 32,
|V_DDx| min and |V_DDx| min removed.
23-Sep-2008 10 Note 2 added to Table 8: General operating conditions on page 33.
Measurement conditions specified in Section 5.3.5: Supply current
characteristics on page 36.
I_DD in standby mode at 85 °C modified in Table 15: Typical and maximum
current consumptions in Stop and Standby modes on page 39.
General input/output characteristics on page 55 modified.
Note added below Table 53: Ordering information scheme.
Section 7.1: Future family enhancements removed. Small text changes.
DocID13586 Rev 16
87/90
89