UM0934 Datasheet, PDF (67/113 Pages) STMicroelectronics – ST7570 S-FSK power line networking System-on-Chip

UM0934
Management information base (MIB)
Table 71. Database objects (continued)
Index
Name
Factory default
R/W
0083h
0084h
0085h
Received alarm counter
Transmitted alarm counter
Alarm repeater
Alarm before indication
Alarm reject window
0
R/W
0
R/W
08h
02h
R/W
09h
0086h
0087h
...
009Fh
Alarm indication
Repetition disable
SN indication disable
Unused
Enabled (0)
Enabled (0)
R/W
Disabled (1)
---
---
00A0h
00A1h
00A2h
00A3h
New synchronization
PLC configuration
Reserved
Reserved
0
W
PHY mode, IDLE state, bit rate 1200 bits/s, ZC PLL
50 Hz, f₀=74.0kHz, f₁=63.3 kHz, current control R/W
disabled
--
--
--
--
00A4h Programmable digital I/O pins
00ABh
Max PGA Gain
00ACh
Soft start
00C2h
Time-slot reset bit
PRESLOT (0), OFF (0)
8
0000Ah
1
R/W
R/W
R/W
R/W
00D1h ZC delay compensation
0
R/W
6.5
6.5.1
MIB parameters
In this section all the MIB object are described in detail.
0000h (first and last initiator address, FIMA/LIMA)
This object stores the values of the FIMA (first initiator MAC address) and LIMA (last initiator
MAC address) addresses.
Table 72. MIB object 0000h: Write request data format
Byte Label
Description
Available range
0..1 FIMA
2..3 LIMA
First initiator MAC address
Last initiator MAC address
0000h .. 0FFFh
0000h .. 0FFFh
Factory default
0C00h
0DFFh
Read/write confirm data format:
The same as write request.
Doc ID 17389 Rev 2
67/113