STEF033 Datasheet, PDF (5/25 Pages) STMicroelectronics – Electronic fuse for 3.3 V line

STEF033
3
Maximum ratings
Maximum ratings
Note:
Table 2. Absolute maximum ratings
Symbol
Parameter
Value
Unit
V_CC
Positive power supply voltage
V_OUT pin voltage
V_OUT/source
V_OUT pin voltage (100 ms)
Current limit pin voltage
I-Lim+/I-Lim-
Current limit pin voltage (100 ms)
En/Fault Enable/Fault pin voltage
- 0.3 to 10
V
- 0.3 to 7
V
- 0.3 to Vcc+0.3
-0.3 to 7
V
- 0.3 to V_CC+0.3
- 0.3 to 4.6
V
dv/dt
T_OP
T_STG
T_LEAD
dv/dt pin voltage
Operating junction temperature range⁽¹⁾
Storage temperature range
Lead temperature (soldering) 10 sec
- 0.3 to 4.6
V
- 40 to 125
°C
- 65 to 150
°C
260
°C
1. The thermal limit is set above the maximum thermal rating. It is not recommended to operate the device at
temperatures greater than the maximum ratings for extended periods of time.
Absolute maximum ratings are those values beyond which damage to the device may occur.
Functional operation under these conditions is not implied.
Table 3. Recommended operating condition
Symbol
Parameter
Value
Unit
V_CC
R-limit
C_dv/dt
V_EN
Positive power supply voltage
Current limitation resistor range, STEF033, STEF033A
Current limitation resistor range, STEF033J, STEF033JA
Soft-start capacitor range
Enable/Fault pin voltage
3.1 to 8
V
10 to 120
Ω
15 to 120
0 to 1
nF
0 to 3.6
V
Table 4. Thermal data
Symbol
Parameter
Thermal resistance junction-ambient, DFN10
R_thJA
Thermal resistance junction-ambient, Flip Chip
R_thJC Thermal resistance junction-case, DFN10
Value
70
90
34
Unit
°C/W
DocID025099 Rev 2
5/25
25