STM8S003K3T6C Datasheet, PDF (47/100 Pages) STMicroelectronics – Value line, 16 MHz STM8S 8-bit MCU, 8 Kbytes Flash, 128 bytes data EEPROM, 10-bit ADC, 3 timers, UART, SPI, I²C

STM8S003K3 STM8S003F3
Electrical characteristics
Figure 8: Pin input voltage
STM8 pin
VIN
9.2
Absolute maximum ratings
Stresses above those listed as ‘absolute maximum ratings’ may cause permanent damage
to the device. This is a stress rating only and functional operation of the device under these
conditions is not implied. Exposure to maximum rating conditions for extended periods may
affect device reliability.
Symbol
V_DDx - V_SS
Table 15: Voltage characteristics
Ratings
Min
Max
Unit
Supply voltage⁽¹⁾
-0.3
6.5
V_IN
Input voltage on true open drain pins⁽²⁾
V_SS - 0.3 6.5
V
|V_DDx - V_DD|
|V_SSx - V_SS|
Input voltage on any other pin⁽²⁾
V_SS - 0.3 V_DD + 0.3
Variations between different power pins
Variations between all the different ground
pins
50
mV
50
V_ESD
Electrostatic discharge voltage
See "Absolute
maximum ratings
(electrical sensitivity)"
(1) _{All power (VDD) and ground (VSS) pins must always be connected to the external power supply}
(2) _{IINJ(PIN) must never be exceeded. This is implicitly insured if VIN maximum is respected. If VIN maximum}
cannot be respected, the injection current must be limited externally to the I_INJ(PIN) value. A positive
injection is induced by V_IN>V_DD while a negative injection is induced by V_IN<V_SS. For true open-drain
pads, there is no positive injection current, and the corresponding V_IN maximum must always be respected
Symbol
I_VDD
Table 16: Current characteristics
Ratings
Total current into V_DD power lines (source)⁽²⁾
Max⁽¹⁾
100
Unit
mA
DocID018576 Rev 3
47/100