English
Language : 

TS4962M_07 Datasheet, PDF (3/41 Pages) STMicroelectronics – 3W filter-free class D audio power amplifier
TS4962M
1
Absolute maximum ratings
Absolute maximum ratings
Table 1. Absolute maximum ratings
Symbol
Parameter
Value
Unit
VCC
Vin
Toper
Supply voltage(1), (2)
Input voltage (3)
Operating free-air temperature range
6
V
GND to VCC
V
-40 to + 85
°C
Tstg
Storage temperature
-65 to +150
°C
Tj
Maximum junction temperature
150
Rthja
Thermal resistance junction to ambient (4)
200
°C
°C/W
Pdiss
Power dissipation
Internally Limited(5)
ESD Human body model
2
kV
ESD Machine model
200
V
Latch-up Latch-up immunity
200
mA
VSTBY Standby pin voltage maximum voltage (6)
GND to VCC
V
Lead temperature (soldering, 10sec)
260
°C
1. Caution: This device is not protected in the event of abnormal operating conditions, such as for example,
short-circuiting between any one output pin and ground, between any one output pin and VCC, and
between individual output pins.
2. All voltage values are measured with respect to the ground pin.
3. The magnitude of the input signal must never exceed VCC + 0.3V / GND - 0.3V.
4. The device is protected in case of over temperature by a thermal shutdown active @ 150°C.
5. Exceeding the power derating curves during a long period causes abnormal operation.
6. The magnitude of the standby signal must never exceed VCC + 0.3V / GND - 0.3V.
Table 2. Operating conditions
Symbol
Parameter
Value
Unit
VCC
VIC
VSTBY
RL
Rthja
Supply voltage(1)
Common mode input voltage range(2)
Standby voltage input: (3)
Device ON
Device OFF
Load resistor
Thermal resistance junction to ambient (5)
2.4 to 5.5
0.5 to VCC - 0.8
1.4 ≤ VSTBY ≤ VCC
GND ≤VSTBY ≤0.4 (4)
≥4
90
V
V
V
Ω
°C/W
1. For VCC from 2.4V to 2.5V, the operating temperature range is reduced to 0°C ≤Tamb ≤70°C.
2. For VCC from 2.4V to 2.5V, the common mode input range must be set at VCC/2.
3. Without any signal on VSTBY, the device will be in standby.
4. Minimum current consumption is obtained when VSTBY = GND.
5. With heat sink surface = 125mm2.
3/41