STM32F102C6T6A Datasheet, PDF (29/69 Pages) STMicroelectronics – Low-density USB access line, ARM-based 32-bit MCU with 16/32 KB Flash, USB FS interface, 5 timers, ADC & 5 communication interfaces

STM32F102x4, STM32F102x6
Electrical characteristics
5.3.5
Table 11. Embedded internal reference voltage
Symbol
Parameter
Conditions
Min Typ Max Unit
V_REFINT Internal reference voltage
–40 °C < T_A < +85 °C 1.16
T_{S_vrefint(1)}
ADC sampling time when reading
the internal reference voltage
V_RERINT(2)
Internal reference voltage spread
over the temperature range
V_DD = 3 V ±10 mV
T_Coeff(2) Temperature coefficient
1.20 1.24 V
5.1 _17.1⁽²⁾ µs
10 mV
100
ppm/
°C
1. Shortest sampling time can be determined in the application by multiple iterations.
2. Guaranteed by design, not tested in production.
Supply current characteristics
The current consumption is a function of several parameters and factors such as the
operating voltage, ambient temperature, I/O pin loading, device software configuration,
operating frequencies, I/O pin switching rate, program location in memory and executed
binary code.
The current consumption is measured as described in Figure 9: Current consumption
measurement scheme.
All Run-mode current consumption measurements given in this section are performed with a
reduced code that gives a consumption equivalent to Dhrystone 2.1 code.
Maximum current consumption
The MCU is placed under the following conditions:
● All I/O pins are in input mode with a static value at V_DD or V_SS (no load)
● All peripherals are disabled except if it is explicitly mentioned
● The Flash access time is adjusted to f_HCLK frequency (0 wait state from 0 to 24 MHz, 1
wait state from 24 to 48 MHz)
● Prefetch in on (reminder: this bit must be set before clock setting and bus prescaling)
● When the peripherals are enabled f_PCLK1 = f_HCLK/2, f_PCLK2 = f_HCLK
The parameters given in Table 12 are derived from tests performed under ambient
temperature and V_DD supply voltage conditions summarized in Table 8.
Doc ID 15057 Rev 3
29/69