STR710-EVAL Datasheet, PDF (26/27 Pages) STMicroelectronics – Evaluation Board for STR71xF

5 Revision history
5 Revision history
STR710-EVAL
Date
Revision
Changes
26-September-2005
4-October-2005
1
Initial external release.
2
Amended Section 2.1 on page 6 to list the JTAG connector CN9.
Amended Section 2.8 on page 6 to improve the USB interface
description.
Amended Section 2.9 on page 7 to improve the CAN interface
description.
Updated Table 4: Option jumpers on page 10 to show J5 is not fitted.
Amended the wording for SW1 in Table 5 on page 10.
Amended the first table entry in Table 11 on page 14.
Updated Chapter 4: Schematics:
Figure 11 on page 15:
C80 is now marked as “Do not fit”, IC20 reset circuit has a threshold
voltage of 3.07 V not 2.63 V.
Figure 12 on page 16 J5 marked as “Do not fit”.
Figure 15 on page 19 IC2 shown with correct connectivity. Note that
on the PCB, IC2 is connected with In/Out swapped.
Figure 19 on page 23, R92 is now removed because it was in
parallel with R83.
Updated Section 2.9: CAN interface on page 7 to include caution.
Updated Chapter 4: Schematics to include the latest revision of
schematics.
Removed list of third party support vendors from description.
25/27