STM32F372VBT6 Datasheet, PDF (24/131 Pages) STMicroelectronics – ARM Cortex-M4 32b MCU+FPU, up to 256KB Flash+32KB SRAM

Functional overview
STM32F37xxx
The RTC is an independent BCD timer/counter. Its main features are the following:
• Calendar with subsecond, seconds, minutes, hours (12 or 24 format), week day, date,
month, year, in BCD (binary-coded decimal) format.
• Automatic correction for 28th, 29th (leap year), 30th and 31st day of the month.
• 2 programmable alarms with wake up from Stop and Standby mode capability.
• Periodic wakeup unit with programmable resolution and period.
• On-the-fly correction from 1 to 32767 RTC clock pulses. This can be used to
synchronize it with a master clock.
• Digital calibration circuit with 1 ppm resolution, to compensate for quartz crystal
inaccuracy.
• 3 anti-tamper detection pins with programmable filter. The MCU can be woken up from
Stop and Standby modes on tamper event detection.
• Timestamp feature which can be used to save the calendar content. This function can
triggered by an event on the timestamp pin, or by a tamper event. The MCU can be
woken up from Stop and Standby modes on timestamp event detection.
• Reference clock detection: a more precise second source clock (50 or 60 Hz) can be
used to enhance the calendar precision.
The RTC clock sources can be:
• A 32.768 kHz external crystal
• A resonator or oscillator
• The internal low-power RC oscillator (typical frequency of 40 kHz)
• The high-speed external clock divided by 32
3.19
Inter-integrated circuit interface (I²C)
Up to two I²C bus interfaces can operate in multimaster and slave modes. They can support
standard (up to 100 kHz), fast (up to 400 kHz) and fast mode + (up to 1 MHz) modes with
20 mA output drive. They support 7-bit and 10-bit addressing modes, multiple 7-bit slave
addresses (2 addresses, 1 with configurable mask). They also include programmable
analog and digital noise filters.
Table 6. Comparison of I²C analog and digital filters
Analog filter
Digital filter
Pulse width of
suppressed spikes
Benefits
≥ 50 ns
Available in Stop mode
Drawbacks
Variations depending on
temperature, voltage, process
Programmable length from 1 to 15
I²C peripheral clocks
1. Extra filtering capability vs.
standard requirements.
2. Stable length
Wakeup from Stop on address
match is not available when digital
filter is enabled
In addition, they provide hardware support for SMBUS 2.0 and PMBUS 1.1: ARP capability,
Host notify protocol, hardware CRC (PEC) generation/verification, timeout verifications and
24/131
DocID022691 Rev 4