TDA7540N Datasheet, PDF (22/76 Pages) STMicroelectronics – AM/FM car radio tuner IC with stereo decoder and intelligent selectivity system (ISS)

Electrical specifications
TDA7540N
Table 8.
Stereodecoder electrical characteristics (continued)
(T_amb = 25°C, V_CC1 = V_CC2 = V_CC3 = V_CCST= V_CCVCO = V_CCMIX1 = V_CCMIX2 = V_CCIF1 = 8.5V,
V_MPX = 500mV_rms mono, f = 1kHz, deemphasis = 50µs, f_Xtal = 10.25MHz, in application
circuit, unless otherwise specified).
Symbol
Parameter
Test conditions
Min. Typ. Max. Unit
V_PEAK
V_PEAK
V_PEAK
V_PEAKDEV
Peak voltage
Peak voltage
Peak voltage
Min. deviation dependent
peak voltage
NBRR = 00, V_MPX=0mV
V_MPX=50mV, f=150kHz
V_MPX=200mV, f=150kHz
V_MPX=500mV, NBDTH = 11
0.5
0.8 1.0
V
1.6
1.9 2.1
V
2.2
2.5 2.7
V
0.5 0.8 (off) 1.0
V_OP
Max. deviation dependent
V_{PEAKDEV peak voltage}
V_MPX=500mV, NBDTH= 00
1.7
2.0
2.2
V_OP
V_PEAKFS
V_PEAKFS
T_S
T_S
SR_PEAK
SR_PEAK
V_RECTADJ
V_RECTADJ
V_RECTADJ
V_RECTADJ
Min. fieldstrength controlled
peak voltage
Max. fieldstrength controlled
peak voltage
Min. blanking time
Max. blanking time
Noise rectifier charge
Noise rectifier charge
Noise rectifier discharge
adjustment
Noise rectifier discharge
adjustment
Noise rectifier discharge
adjustment
Noise rectifier discharge
adjustment
V_MPX=0mV, V_LEVEL<< V_SBL
(fully mono), NBFS = 11
V_MPX=0mV, V_LEVEL<< V_SBL
(fully mono), NBFS = 00
Signal HOLDN in testmode,
NBT
Signal HOLDN in testmode,
NBT
Signal PEAK in testmode,
NBPC=0
Signal PEAK in testmode,
NBPC=1
Signal PEAK in testmode,
NBRR=00, NBSMP=0,
MPPC=0
Signal PEAK in testmode,
NBRR=01, NBSMP=0,
MPPC=0
Signal PEAK in testmode,
NBRR=10, NBSMP=0,
MPPC=0
Signal PEAK in testmode,
NBRR=11, NBSMP=0,
MPPC=0
0.5 0.8 (off) 1.0
V
1.7
2.0 2.2
V
22
μs
38
μs
10
mV/μs
20
mV/μs
0.3
V/ms
0.8
V/ms
1.3
V/ms
2.0
V/ms
V_ADJMP
V_ADJMP
Noise rectifier adjustment by
multipath
Noise rectifier adjustment by
strong multipath influence
Signal PEAK in testmode,
V_MPTC=1V, NBSMP=0,
MPPC=1, NBRR=01
Signal PEAK in testmode,
V_MPTC=1V,, NBSMP=1,
MPPC=0, NBRR=01
2.5
V/ms
3.3
V/ms
V_ADJMP
Noise rectifier adjustment by Signal PEAK in testmode,
multipath and strong multipath V_MPTC=1V,, NBSMP=1,
influence
MPPC=1A, NBRR=01
4.5
V/ms
22/76