P-NUCLEO-CLD1 Datasheet, PDF (2/4 Pages) STMicroelectronics – The STM32 Nucleo pack P-NUCLEO-CLD1

Kit description
P-NUCLEO-CLD1
1
Kit description
The NUCLEO-F401RE board provides an affordable and flexible way for users to try out
new concepts and to build prototypes with STM32 MCU. It does not require any separate
probe as it integrates the ST-LINK/V2-1 debugger and programmer.
The X-NUCLEO-IDW01M1 is a Wi-Fi expansion board for STM32 Nucleo based on the
SPWF01SA module. The CE, IC and FCC certified SPWF01SA module has an embedded
STM32 MCU, a low-power Wi-Fi b/g/n SoC with integrated power amplifier and power
management and an SMD antenna. The SPWF01SA module is also equipped with 1
MByte of external FLASH for firmware update over-the-air (FOTA).
The X-NUCLEO-IKS01A2 is a motion MEMS and environmental sensor expansion board
for the STM32 Nucleo. It is designed around the LSM6DSL 3D accelerometer and 3D
gyroscope, the LSM303AGR 3D accelerometer and 3D magnetometer, the HTS221
humidity and temperature sensor and the LPS22HB pressure sensor.
The X-NUCLEO-NFC01A1 is a Dynamic NFC tag expansion board for the STM32 Nucleo.
It is designed around the M24SR64-Y. The M24SR64-Y device is a dynamic NFC/RFID tag
IC with a dual interface. It embeds a 64 Kbit EEPROM memory. It can be operated from an
I²C interface or by a 13.56 MHz RFID reader or a NFC phone.
The X-NUCLEO-IDW01M1, X-NUCLEO-IKS01A2 and X-NUCLEO-NFC01A1 support with
the Arduino UNO R3 connectivity.
The FP-CLD-AZURE1 function pack directly connects your IoT node to the Microsoft Azure
IoT. The software implements application level functions based on the HTTP protocol and
enables communication with Microsoft Azure IoT. You can use it to prototype end-to-end
IoT applications together with Microsoft Azure, and transmit real time sensor data and
receive commands. The software runs on the STM32 microcontroller and includes drivers
for the Wi-Fi module, sensors and dynamic NFC/RFID tag; the package bundles examples
for transmitting sensor data and controlling the device via Microsoft Azure IoT.
The FP-CLD-WATSON1 function pack can connect your IoT node to IBM Watson IoT. The
software includes a middleware package implementing the MQTT protocol to facilitate
interaction between the STM32 Nucleo board and Cloud services. The package is further
extended with pre-integrated algorithms for the processing of accelerometers data that can
be used to detect vibration from devices such as motors, fans and pumps. Maximum
frequencies and tear/wear conditions of the device under test are reported together with
raw sensors data to IBM Watson IoT thus enabling and speeding up development of
solutions for industrial condition monitoring and predictive maintenance. FP-CLD-AZURE1
and FP-CLD-WATSON1 are not included in the kit but they are downloadable from
www.st.com.
2/4
DocID030439 Rev 1