STM32F383XX Datasheet, PDF (123/125 Pages) STMicroelectronics – Reset and power management

STM32F383xx
9
Revision history
Revision history
Date
18-Jan-2013
19-Sep-2013
Table 78. Document revision history
Revision
Changes
1
Initial release.
Replaced “Cortex-M4F” with “Cortex-M4” throughout the
document.
Removed part number STM32F382xx.
Added “1.25 DMIPS/MHz (Dhrystone 2.1)” in Features.
Removed all references to pin PB2.
Updated Introduction.
Added reference to the STMTouch touch sensing firmware
library in Section 3.16: Touch sensing controller (TSC).
Added “All I2S interfaces can operate in half-duplex mode
only.” in Section 3.21: Serial peripheral interface (SPI)/Inter-
integrated sound interfaces (I2S).
Modified introduction of I2C interface characteristics.
Added alternate function RTC_REFIN and removed additional
function RTC_REF_CLK_IN to pins PA1 and PB15.
Replaced alternate function JNTRST with NJTRST for pin
PB4.
Replaced alternate function TIM1_TX with USART1_TX for
pin PC4 and TIM1_RX with USART1_RX for pin PC5.
Added alternate functions TIM4_CH1 and TSC_G8_IO1 to
pin PD12. Removed additional functions TIM4_CH1 and
G8_IO1 from pin PD12.
2
Added row “I2S full-duplex mode” to Table 9: STM32F383xx
SPI/I2S implementation.
In Table 12: Alternate functions for port PA: replaced alternate
function JTMS-SWDIO with SWDIO-JTMS for pin PA13, and
JTCK-SWCLK with SWCLK-JTCK for pin PA14.
In Table 22: General operating conditions: added rows V_REF+
and V_REFSD+; changed minimum value of V_DDSD12 (‘SDADC
not used’ condition) from 2.0 to 1.65.
Replaced table column heading "Typ@VDD (VDD = VDDA =
1.8 V)" with "Typ@VDD (VDD=1.8 V, VDDA=3.3 V)" in
Table 28: Typical and maximum VDD consumption in Stop
mode.
Updated Table 29: Typical and maximum VDDA consumption
in Stop mode.
Added conditions for f_{HSE_ext} in Table 35: High-speed external
user clock characteristics.
Added Min and Max values for ACC_HISI in Table 39: HSI
oscillator characteristics.
Added COMP in Table 33: Peripheral current consumption
Changed V_DDA value from 1.8 to 3.3 V in note⁽¹⁾ under
Table 39: HSI oscillator characteristics and Table 40: LSI
oscillator characteristics.
DocID023367 Rev 2
123/125
124