English
Language : 

SPC56EL60X Datasheet, PDF (119/165 Pages) STMicroelectronics – Dual issue five-stage pipeline core
SPC56ELx, SPC564Lx
Electrical characteristics
2. With FM; the value does not include a possible +2% modulation
3. “Loss of Reference Frequency” window is the reference frequency range outside of which the FMPLL is in self clocked
mode.
4. Self clocked mode frequency is the frequency that the FMPLL operates at when the reference frequency falls outside the
fLOR window.
5.
fffVSSYCCSOM
is the frequency at the output of the VCO; its range is 256–512 MHz.
is the self-clocked mode frequency (free running frequency); its range
= fVCOODF
is
20–150
MHz.
6. This value is determined by the crystal manufacturer and board design. For 4 MHz to 20 MHz crystals specified for this
FMPLL, load capacitors should not exceed these limits.
7. This specification applies to the period required for the FMPLL to relock after changing the MFD frequency control bits in
the synthesizer control register (SYNCR).
8. This value is determined by the crystal manufacturer and board design.
9.
Jitter is the average deviation
Measurements are made with
from the programmed frequency measured over the
the device powered by filtered supplies and clocked
specified interval at
by a stable external
mclaoxcikmsuigmnafSl.YNS.oise
injected into the FMPLL circuitry
percentage for a given interval.
via
VDDPLL
and
VSSPLL
and
variation
in
crystal
oscillator
frequency
increase
the
CJITTER
10. Proper PC board layout procedures must be followed to achieve specifications.
11.
Values are with frequency modulation disabled.
fCS or fDS (depending on whether center spread
If frequency modulation is enabled, jitter
or down spread modulation is enabled).
is
the
sum
of
CJITTER
and
either
12. Modulation depth is attenuated from depth setting when operating at modulation frequencies above 50 kHz.
3.15 16 MHz RC oscillator electrical characteristics
Table 26. 16 MHz RC oscillator electrical characteristics
Symbol C
Parameter
Conditions
Value
Min Typ
fRC
RCMVAR
P RC oscillator frequency
Fast internal RC oscillator variation over
P temperature and supply with respect to fRC at
TA = 25 °C in high-frequency configuration
TA = 25 °C
—
—
16
6
—
Unit
Max
— MHz
6
%
3.16
ADC electrical characteristics
The device provides a 12-bit Successive Approximation Register (SAR) Analog-to-Digital
Converter.
DocID15457 Rev 12
119/165
164