English
Language : 

M59MR032C Datasheet, PDF (10/49 Pages) STMicroelectronics – 32 Mbit 2Mb x16, Mux I/O, Dual Bank, Burst 1.8V Supply Flash Memory
M59MR032C, M59MR032D
DEVICE OPERATIONS
The following operations can be performed using
the appropriate bus cycles: Address Latch, Read
Array (Random, and Page Modes), Write com-
mand, Output Disable, Standby, Reset/Power-
down and Block Locking. See Table 8.
Address Latch. In asynchronous operation, the
address is latched on the rising edge of L input; in
burst mode, the address is latched either by L go-
ing high or with a rising/falling edge of K, depend-
ing on the clock configuration.
Read. Read operations are used to output the
contents of the Memory Array, the Electronic Sig-
nature, the Status Register, the CFI, the Block
Protection Status, the Configuration Register sta-
tus and the Security Code.
Read operation of the Memory Array may be per-
formed in asynchronous page mode or synchro-
nous burst mode. In asynchronous page mode
data is internally read and stored in a page buffer.
The page has a size of 4 words and is addressed
by ADQ0 and ADQ1 address inputs.
According to the device configuration the following
Read operations: Electronic Signature - Status
Register - CFI - Block Protection Status - Configu-
ration Register Status - Security Code must be ac-
cessed as asynchronous read or as single
synchronous burst mode (see Figure 4). Both Chip
Enable E and Output Enable G must be at VIL in
order to read the output of the memory.
Table 8. User Bus Operations (1)
Operation
E
G
W
RP
WP
ADQ0-ADQ15
Write
VIL
VIH
VIL
VIH
VIH
Data Input
Output Disable
VIL
VIH
VIH
VIH
VIH
Hi-Z
Standby
VIH
X
X
VIH
VIH
Hi-Z
Reset / Power-down
X
X
X
VIL
VIH
Hi-Z
Block Locking
VIL
X
X
VIH
VIL
X
Note: 1. X = Don’t care.
Table 9. Read Electronic Signature (AS and Read CFI instructions) (1)
Code
Device
E
G
W
A0-A7
Manufacturer Code
VIL
VIL
VIH
00h
Device Code
M59MR032C
VIL
VIL
VIH
01h
M59MR032D
VIL
VIL
VIH
01h
Note: 1. Addresses are latched on the rising edge of L input.
A8-A20
Don’t Care
Don’t Care
Don’t Care
Data
0020h
00A4h
00A5h
Table 10. Read Block Protection (AS and Read CFI instructions) (1)
Block Status
E
G
W
A0-A7
A8-A11
Protected and
unlocked
VIL
VIL
VIH
02h
Don’t Care
Unprotected and
unlocked
VIL
VIL
VIH
02h
Don’t Care
Protected and locked VIL
VIL
VIH
02h
Don’t Care
Unprotected and
locked (2)
VIL
VIL
VIH
02h
Don’t Care
Note: 1. Addresses are latched on the rising edge of L input.
2. A locked block can be unprotected only with WP at VIH.
A12-A20
Block Address
Block Address
Block Address
Block Address
Data
0001
0000
0003
0002
10/49