VNQ810M-E Datasheet, PDF (1/21 Pages) STMicroelectronics – QUAD CHANNEL HIGH SIDE DRIVER

VNQ810M-E
QUAD CHANNEL HIGH SIDE DRIVER
Table 1. General Features
Type
R_DS(on)
I_out
V_CC
VNQ810M-E
150mΩ (*) 0.6A (*)
36V
(*) Per each channel
s CMOS COMPATIBLE INPUTS
s OPEN DRAIN STATUS OUTPUTS
s ON STATE OPEN LOAD DETECTION
s OFF STATE OPEN LOAD DETECTION
s SHORTED LOAD PROTECTION
s UNDERVOLTAGE AND OVERVOLTAGE
SHUTDOWN
s PROTECTION AGAINST LOSS OF GROUND
s VERY LOW STAND-BY CURRENT
s REVERSE BATTERY PROTECTION (**)
s IN COMPLIANCE WITH THE 2002/95/EC
EUROPEAN DIRECTIVE
Figure 1. Package
SO-28 (DOUBLE ISLAND)
DESCRIPTION
The VNQ810M-E is a quad HSD formed by
assembling two VND810M-E chips in the same
SO-28 package. The VNQ810M-E is a monolithic
device made by using STMicroelectronics
VIPower M0-3 Technology, intended for driving
any kind of load with one side connected to
ground. Active V_CC pin voltage clamp protects the
device against low energy spikes (see ISO7637
transient compatibility table).
Active current limitation combined with thermal
shutdown and automatic restart protects the
device against overload. The current limitation
threshold is aimed at detecting the 21W/12V
standard bulb as an overload fault. The device
detects open load condition both in on and off
state . Output shorted to V_CC is detected in the off
state. Device automatically turns off in case of
ground pin disconnection.
Table 2. Order Codes
Package
SO-28
Tube
VNQ810M-E
Note: (**) See application schematic at page 10
October 2004
Tape and Reel
VNQ810MTR-E
Rev. 1
1/21