|
VN5E160S-E Datasheet, PDF (1/34 Pages) STMicroelectronics – Single channel high side driver for automotive applications | |||
|
VN5E160S-E
Single channel high side driver for automotive applications
Features
Max transient supply voltage
Operating voltage range
Max On-state resistance (per ch.)
VCC
41V
VCC 4.5 to 28V
RON 160 mâ¦
Current limitation (typ)
Off state supply current
ILIMH
IS
10A
2 µA(1)
1. Typical value with all loads connected.
â General
â Inrush current active management by
power limitation
â Very low stand-by current
â 3.0V CMOS compatible inputs
â Optimized electromagnetic emissions
â Very low electromagnetic susceptibility
â In compliance with the 2002/95/EC
european directive
â Diagnostic functions
â Open Drain status output
â On-state open load detection
â Off-state open load detection
â Output short to VCC detection
â Overload and short to ground (power
limitation) indication
â Thermal shutdown indication
â Protections
â Undervoltage shutdown
â Overvoltage clamp
â Load current limitation
â Self limiting of fast thermal transients
â Protection against loss of ground and loss
of VCC
â Over-temperature shutdown with
autorestart (thermal shutdown)
â Reverse battery protected (a)
â Electrostatic discharge protection
SO-8
Application
â All types of resistive, inductive and capacitive
loads
Description
The VN5E160S-E is a single channel high-side
driver manufactured in the ST proprietary
VIPower M0-5 technology and housed in the tiny
SO-8 package.
The VN5E160S-E is designed to drive automotive
grounded loads delivering protection, diagnostics
and easy 3V and 5V CMOS-compatible interface
with any microcontroller.
The device integrates advanced protective
functions such as load current limitation, inrush
and overload active management by power
limitation, over-temperature shut-off with auto-
restart and over-voltage active clamp.
A dedicated active low digital status pin is
associated with every output channel in order to
provide Enhanced diagnostic functions including
fast detection of overload and short-circuit to
ground, over-temperature indication, short-circuit
to VCC diagnosis and ON & OFF state open-load
detection.
The diagnostic feedback of the whole device can
be disabled by pulling the STAT_DIS pin up, thus
allowing wired-ORing with other similar devices.
a. See Figure 32: Application schematic.
February 2008
Rev 2
1/34
www.st.com
34
|
▷ |