M29F040 Datasheet, PDF (1/31 Pages) STMicroelectronics – 4 Mbit 512Kb x8, Uniform Block Single Supply Flash Memory

M29F040
4 Mbit (512Kb x8, Uniform Block) Single Supply Flash Memory
M29F040 is replaced by the M29F040B
5V ± 10% SUPPLY VOLTAGE for PROGRAM,
ERASE and READ OPERATIONS
FAST ACCESS TIME: 70ns
BYTE PROGRAMMING TIME: 10µs typical
ERASE TIME
– Block: 1.0 sec typical
– Chip: 2.5 sec typical
PROGRAM/ERASE CONTROLLER (P/E.C.)
– Program Byte-by-Byte
– Data Polling and Toggle bits Protocol for
P/E.C. Status
MEMORY ERASE in BLOCKS
– 8 Uniform Blocks of 64 KBytes each
– Block Protection
– Multiblock Erase
ERASE SUSPEND and RESUME MODES
LOW POWER CONSUMPTION
– Read mode: 8mA typical (at 12MHz)
– Stand-by mode: 25µA typical
– Automatic Stand-by mode
100,000 PROGRAM/ERASE CYCLES per
BLOCK
20 YEARS DATA RETENTION
– Defectivity below 1ppm/year
ELECTRONIC SIGNATURE
– Manufacturer Code: 20h
– Device Code: E2h
Table 1. Signal Names
A0-A18
Address Inputs
DQ0-DQ7 Data Input / Outputs
E
Chip Enable
G
Output Enable
W
Write Enable
V_CC
Supply Voltage
VSS
Ground
NOT FOR NEW DESIGN
PLCC32 (K)
TSOP32 (N)
8 x 20 mm
Figure 1. Logic Diagram
VCC
19
A0-A18
8
DQ0-DQ7
W
M29F040
E
G
VSS
AI01372
November 1999
This is information on a product still in production but not recommended for new designs.
1/31