M27C2001_99 Datasheet, PDF (1/16 Pages) STMicroelectronics – 2 Mbit (256Kb x 8) UV EPROM and OTP EPROM

M27C2001
2 Mbit (256Kb x 8) UV EPROM and OTP EPROM
s 5V ± 10% SUPPLY VOLTAGE in READ
OPERATION
s FAST ACCESS TIME: 55ns
s LOW POWER CONSUMPTION:
– Active Current 30mA at 5MHz
– Standby Current 100µA
s PROGRAMMING VOLTAGE: 12.75V ± 0.25V
s PROGRAMMING TIME: 100µs/byte (typical)
s ELECTRONIC SIGNATURE
– Manufacturer Code: 20h
– Device Code: 61h
DESCRIPTION
The M27C2001 is a high speed 2 Mbit EPROM of-
fered in the two ranges UV (ultra violet erase) and
OTP (one time programmable). It is ideally suited
for microprocessor systems requiring large pro-
grams and is organised as 262,144 by 8 bits.
The FDIP32W (window ceramic frit-seal package)
and LCCC32W (leadless chip carrier package)
have a transparent lids which allow the user to ex-
pose the chip to ultraviolet light to erase the bit pat-
tern. A new pattern can then be written to the
device by following the programming procedure.
For applications where the content is programmed
only one time and erasure is not required, the
M27C2001 is offered in PDIP32, PLCC32 and
TSOP32 (8 x 20 mm) packages.
Table 1. Signal Names
A0-A17
Address Inputs
Q0-Q7
Data Outputs
E
Chip Enable
G
Output Enable
P
Program
V_PP
Program Supply
V_CC
Supply Voltage
V_SS
Ground
32
1
FDIP32W (F)
32
1
PDIP32 (B)
LCCC32W (L)
PLCC32 (K)
Figure 1. Logic Diagram
TSOP32 (N)
8 x 20 mm
VCC VPP
18
A0-A17
8
Q0-Q7
P
M27C2001
E
G
VSS
AI00716B
April 1999
1/16