SPW1653JPTE-12-TR Datasheet, PDF (10/24 Pages) STANLEY ELECTRIC CO.,LTD. – ・6 Dies product, Special color emitting LED (Purplish Pink)

Soldering condition
SPW1653JPTE-12-TR
4. If soldering manually, Stanley recommends using a soldering iron equipped with temperature control.
During the actual soldering process, make sure that the soldering iron never touches the LED itself, and
avoid the LED's electrode heating temperature reaching above the heating temperature of the solder
pad. All repairs must be performed only once in the same spot, and please avoid reusing components.
5. In soldering process, immediately after iron tip is cleaned, please make sure that the soldering iron
reaches the appropriate temperature, before using. Also, please avoid applying any types of pressure to
the soldered components before the solder has been cooled and hardened, as it may deteriorate solder
performance and solder quality.
6. When using adhesive material for tentative fixatives, thermosetting resin or Ultraviolet radiation (UV)
setting resin with heat shall be recommended.
【Recommended Manual Soldering Condition】
Temperature of Iron Tip
Soldering Duration, Time
350ˆMAX.
3sec.Max., Once
7. Flow soldering (dip soldering) is not recommended for this product.
8. Isopropyl alcohol is recommended for cleaning. Some chemicals, including Freon substitute detergent
could corrode the lens or the casing surface, which cause discoloration, cloud, crack and so on. Please
review the reference chart below for cleaning. If water is used to clean (including the final cleaning
process), please use pure water (not tap water), and completely dry the component before using.
《The curing condition, Temperature:150ˆMax./Time:120sec.Max.》
Chemical
Ethyl Alcohol
Isopropyl Alcohol
Pure Water
Trichloroethylene
Chlorothene
Acetone
Thinner
Adaptability
○
○
○
×
×
×
×
2013.10.08
Page : 10