JGN1104LS-AR Datasheet, PDF (10/23 Pages) STANLEY ELECTRIC CO.,LTD. – Wide range temperature applicable product

Soldering condition
JGN1104LS-AR
4. If soldering manually, Stanley recommends using a soldering iron equipped with temperature control. During
the actual soldering process, make sure that the soldering iron never touch the LED itself, and avoid the LED's
electrode heating temperature reaching above the heating temperature of the solder pad. All repairs must be
performed only once in the same spot, and please avoid reusing components.
5. In soldering process, immediately after iron tip is cleaned, please make sure that the soldering iron reaches the
appropriate temperature before using. Also, please avoid applying any type of pressure to the soldered
components before the solder has been cooled and hardened, as it may deteriorate solder performance and
solder quality.
【Recommended Manual Soldering Condition】
Temperature of Iron Tip
Soldering Duration, Time
350℃MAX.
3sec.Max.,1 time
6. When using adhesive material for tentative fixatives, thermosetting resin or Ultraviolet radiation (UV) setting
resin with heat shall be recommended.
《The curing
condition, Temperature:150℃Max./Time:120sec.Max.》
7. Flow soldering (dip soldering) is not recommended for this product.
8. lsopropyl alcohol is recommended for cleaning. Some chemicals, including Freon substitute detergent could
corrode the lens or the casing surface, which cause discoloration, cloud, crack and so on. Please review the
reference chart below for cleaning. If water is used to clean (including the final cleaning process), please use
pure water (not tap water), and completely dry the component before using.
Chemical
Isopropyl Alcohol
Trichloroethylene
Chlorothene
Acetone
Thinner
Adaptability
○
×
×
×
×
2016.4.15
Page : 10