GDT-C6M Datasheet, PDF (3/3 Pages) StarHope – Gas Discharge Tube C6M Series

SPSEMI
GDT/C6M Series
Surge Characteristics
Test Item
Test Method
Surge withstand capability
In the glass tube ends in 8/20 us surge tester, applying the model that
corresponds to the impact resistance current, time interval for the
60 s of plus or minus the test 5 times. Test the dc voltage,
insulation resistance, static capacitance and check the appearance.
Surge life test
Apply 10KV voltage charged in 1500pF condenser and
apply the current to the specimen,200 times at 10
seconds of intervals.
Specification
DC spark-over voltage
JSE: △Vs/Vs≦30%
Within standard mentioned in
Initial Characteristics.
Enviromental Characteristics
Test Item
Cold resistance
Heat resistance
Temperature resistance
Temperature period
Tensile strength
Bending strength
Resistance to soldering
attachment
（by solder dip）
Resistance to soldering
heat
（by solder dip）
Test Method
After -40±3℃
(1000hrs) / room temp.,normal humidity(4 hrs)
cycle, measure the properties.
After 125±2℃
(1000hrs) / room temp.,normal humidity(4 hrs)
cycle, measure the properties.
After 85±2℃
RH85%(1000hrs) / room temp.,normal humidity(4
hrs) cycle, measure the properties.
25 times repetition of cycle -40±3℃
(30 Min.),roon temp., (4 Min.), 125±2℃(30Min.),
room temp., normal humidity(4hrs) .
Apply 2.5kgs load approximately 30 seconds, then check
for pull-out and breaking of the lead wire.
Bend the lead wire, with jig which radius is 0.75~0.8mm, at the point
of 2mm from the body, under 0.25 kgs load applied at the right angle
the direction of theamis and get the bent lead wire back to its
original poing after the procedure was repeated 2times.
Apply flux and immerse in molten solder, up to the point of
3mm from the body,for 5 sec. (235 ±5 ). Wash
the leadwire and check for soldering adhesion.
Apply flux and immerse in molten solder, up to the point of 3mm
from the body,for 5 sec. (235℃ ±5℃ ). Wash the leadwire
and check forsoldering adhesion.)
Specification
Within standard mentioned in
Initial Characteristics.
Within standard mentioned in
Initial Characteristics.
Within standard mentioned in
Initial Characteristics.
Within standard mentioned in
Initial Characteristics.
Within standard mentioned in
Initial Characteristics.
Within standard mentioned in
Initial Characteristics.
Lead wire is evenly covered by
solder over 90%.
Within standard mentioned in
Initial Characteristics.
REV.2017.04.06
www.spsemi.cn
Page 3 of 3