FTM-9812T-C10 Datasheet, PDF (8/12 Pages) Source Photonics, Inc. – GEPON ONU Triplexer

GEPON ONU Triplexer
IEEE 802.3ah^TM 1000BASE-PX10U
FTM-9812T-C10(G)
Aug. 10, 2007
17
V_{DD_12V}
CATV Receive Power Supply (+12V)
18
ANALOG_SD
Analog Receiver Optical Power Monitor Output
7
19
NC
No Function Definition
20
V_EE
Signal Ground
SMB
RF Output
CATV Receiver RF Analog Output (75Ω)
8
Note 1: LVTTL logic output, with internal 10KΩ pull-up resistor.
Optical Signal-Detected: High; Optical Signal Loss: Low
Note 2: LVPECL logic output, AC coupled internally. (See Recommended Interface Circuit)
Note 3: LVTTL logic input, with internal 10KΩ pull-up resistor.
Transmitter Disabled: High; Transmitter Enabled: Low
Note 4: A positive level enable optical signal output under burst mode.
(See Timing Parameter Definition in Burst Mode Sequence)
Note 5: Compatible with LVPECL input, DC coupled internally
(See Recommended Interface Circuit and Table 7 - Electrical Input/Output Coupling Mode)
Note 6: Reserved for module tuning and compulsive for system application that any circuit doesn’t be connected to
them.
Note 7: Analog output, which can be used to measure CATV receiver input optical power. It should be connected with
A/D converter.
Note 8: SMB Jack connector
Fiberxon Proprietary and Confidential, Do Not Copy or Distribute
Page 8 of 12