SPS-43-48H-HP-XDE Datasheet, PDF (12/13 Pages) Source Photonics, Inc. – 1490nm/1310nm Single Fiber OLT

Mechanical Diagram
SPS-43-48H-HP-xDE
1490nm/1310nm Single Fiber OLT
Table 11 - Device Handling/ESD Protection
The devices are static sensitive and may easily be damaged if care is not taken during handling. The following handling practices are
recommended.
1 Devices should be handled on benches with conductive and grounding surfaces.
2 All personnel, test equipment and tools shall be grounded.
3 Do not handle the devices by their leads.
4 Store devices in protective foam or carriers.
5 Avoid the use of non-conductive plastics, rubber, or silk in the area where the devices are handled
6 All modules shall be packaged in materials that are anti-static to protect against adverse electrical environments.
Avoid applications of any voltage higher than maximum rated voltages to this part. For proper operation, any VIN or VOUT should be
7 constrained to the range GND ≤ (VIN or VOUT) ≤ VCC. Unused inputs must always be tied to an appropriate logic voltage (e.g.
either GND or VCC). Unused outputs must be left open.
DS-6264 Rev 02 2012-06-04