SPS-43-48H-HP-XDE Datasheet, PDF (10/13 Pages) Source Photonics, Inc. – 1490nm/1310nm Single Fiber OLT

SPS-43-48H-HP-xDE
1490nm/1310nm Single Fiber OLT
6E.3
6E.2
6E.1
6E.0
6F.7
6F.6
6F.5
6F.4
111 6F.3
6F.2
6F.1
6F.0
70.7
70.6
70.5
112
70.4
70.3
70.2
70.1
70
71.7
71.6
71.5
71.4
113
71.3
71.2
71.1
71
1bit Rate Select
0
1bit TX_FAULT
x
1bit LOS
0
1bit Data_ready_bar
x
1bit Reserved
0
1bit Reserved
0
1bit Reserved
0
1bit Reserved
0
1bit Reserved
0
1bit INTERRUPT_NOT
x
1bit MODE_EN
0
1bit APD_SHUTDOWN
x
Temperature too high
1bit
x
alarm
Temperature too low
1bit
x
alarm
1bit VCC too high alarm
x
1bit VCC too low alarm
x
1bit BIASMON too high alarm x
1bit BIASMON too low alarm x
1bit BFMON too high alarm x
1bit BFMON too low alarm x
1bit RSSI too high alarm
x
1bit RSSI too low alarm
x
Reserved interrupt status
1bit
x
bit
Reserved interrupt status
1bit
x
bit
Reserved interrupt status
1bit
x
bit
Reserved interrupt status
1bit
x
bit
Reserved interrupt status
1bit
x
bit
1bit Reserved interrupt status x
NOT SUPPORTED.
Digital state of the TX Fault Output Pin.
Digital state of the LOS Output Pin.
NOT SUPPORTED
Indicates transceiver has achieved
power up and data is ready.
Reserved
Reserved
Reserved
Reserved
Reserved
Interrupt state (active low)
TX FAULT pin enable
APD shut‐down latch. Write 0 to clear
condition
Temperature too high alarm
Temperature too low alarm
VCC too high alarm
VCC too low alarm
BIASMON too high alarm
BIASMON too low alarm
BFMON too high alarm
BFMON too low alarm
RSSI too high alarm
RSSI too low alarm
Reserved interrupt status bit
Reserved interrupt status bit
Reserved interrupt status bit
Reserved interrupt status bit
TX Fail went HIGH
APD Shutdown event detected
DS-6264 Rev 02 2012-06-04