|
USB3300_07 Datasheet, PDF (1/55 Pages) SMSC Corporation – Hi-Speed USB Host, Device or OTG PHY with ULPI Low Pin Interface | |||
|
USB3300
Hi-Speed USB Host,
Device or OTG PHY with
ULPI Low Pin Interface
PRODUCT FEATURES
Datasheet
 USB-IF Hi-Speed certified to the Universal Serial Bus
Specification Rev 2.0
 Interface compliant with the ULPI Specification
revision 1.1 in 8-bit mode
 Industry standard UTMI+ Low Pin Interface (ULPI)
Converts 54 UTMI+ signals into a standard 12 pin
Link controller interface
 54.7mA Unconfigured Current (typical) - ideal for bus
powered applications
 83uA suspend current (typical) - ideal for battery
powered applications
 Latch-Up performance exceeds 150 mA per
EIA/JESD 78, Class II
 ESD protection levels of ±8kV HBM without external
protection devices
 Integrated protection to withstand IEC61000-4-2 ESD
tests (±8kV contact and ±15kV air) per 3rd party test
facility
 Supports FS pre-amble for FS hubs with a LS device
attached (UTMI+ Level 3)
 Supports HS SOF and LS keep-alive pulse
 Includes full support for the optional On-The-Go
(OTG) protocol detailed in the On-The-Go
Supplement Revision 1.0a specification
 Supports the OTG Host Negotiation Protocol (HNP)
and Session Request Protocol (SRP)
 Allows host to turn VBUS off to conserve battery
power in OTG applications
 Supports OTG monitoring of VBUS levels with
internal comparators. Includes support for an external
VBUS or fault monitor.
 Low Latency Hi-Speed Receiver (43 Hi-Speed clocks
Max) allows use of legacy UTMI Links with a ULPI
wrapper
 Integrated Pull-up resistor on STP for interface
protection allows a reliable Link/PHY start-up with
slow Links (software configured for low power)
 Internal 1.8 volt regulators allow operation from a
single 3.3 volt supply
 Internal short circuit protection of ID, DP and DM
lines to VBUS or ground
 Integrated 24MHz Crystal Oscillator supports either
crystal operation or 24MHz external clock input
 Internal PLL for 480MHz Hi-Speed USB operation
 Industrial Operating Temperature -40°C to +85°C
 32 pin, QFN lead-free RoHS Compliant package
(5 x 5 x 0.90 mm height)
Applications
The USB3300 is the ideal companion to any ASIC, SoC
or FPGA solution designed with a ULPI Hi-Speed USB
host, peripheral or OTG core.
The USB3300 is well suited for:
 Cell Phones
 PDAs
 MP3 Players
 Scanners
 External Hard Drives
 Digital Still and Video Cameras
 Portable Media Players
 Printers
SMSC USB3300
DATASHEET
Revision 1.08 (11-07-07)
|
▷ |