IRCC2.0 Datasheet, PDF (1/87 Pages) SMSC Corporation – Infrared Communications Controller

IrCC 2.0
PRELIMINARY
Infrared Communications Controller
FEATURES
• Multi-Protocol Serial Communications
Controller
• Full IrDA v1.1 Implementation: 2.4 kbps -
115.2 kbps, 0.576 Mbps, 1.152 Mbps and 4
Mbps
• Consumer Infrared (Remote Control)
Interface
• SHARP Amplitude Shift Keyed Infrared
(ASK IR) Interface
• Direct Rx/Tx Infrared Diode Control (Raw)
and General Purpose Data Pins
• Programmable High-Speed Synchronous
Communications Engine (SCE) with a 128-
Byte FIFO and Programmable Threshold
• Programmable DMA Refresh Counter
• High-Speed NS16C550A-Compatible
Universal Asynchronous Receiver/
Transmitter Interface (ACE UART) with 16-
Byte Send and Receive FIFOs
• ISA Single-Byte and Burst-Mode DMA and
Interrupt-Driven Programmed I/O with Zero
Wait State and String Move Timing
• 16 Bit CRC-CCITT and 32 Bit IEEE 802
CRC32 Hardware CRC Generators
• Automatic Transceiver Control
• Transmit Pulse Width Limiter
• SCE Transmit Delay Timer
• IR Media Busy Indicator
GENERAL DESCRIPTION
This document describes the Infrared
Communications Controller (IrCC 2.0) function,
which is common to a number of SMSC
products. The IrCC 2.0 consists of two main
architectural blocks: the ACE 16C550A UART
and a Synchronous Communications Engine
(SCE) (Figure 2). It’s own unique register set
supports each block.
The IrCC 2.0 UART-driven IrDA SIR and SHARP
ASK modes are backward compatible
with current SMSC Super I/O and Ultra I/O
infrared implementations. The IrCC 2.0 SCE
supports IrDA v1.1 0.576 Mbps, 1.152 Mbps, 4
Mbps, and Consumer IR modes. All of the SCE-
driven modes can use DMA. The IrCC 2.0 offers
flexible signal routing and programmable output
control through the Raw mode interface, General
Purpose Data pins and Output Multiplexer. Chip-
level address decoding is required to access the
IrCC 2.0 register sets.