SKY65206-13 Datasheet, PDF (6/7 Pages) Skyworks Solutions Inc. – WLAN 802.11b/g Intera™ Front-End Module

DATA SHEET • SKY65206-13
Control Pin Table
Pin Name
V_CTL1
V_CTL2
V_CTL3
V_CTL4
Application Board Port Name
C₁
C₂
C₃
C₄
Test Procedure
Use the following procedure to set up the SKY65206 evaluation
board for testing. Refer to the Application Circuit and Board
Layout for guidance:
1. Connect a 3.3 V supply to V_CC. If available, enable the current
limiting function of the power supply to 600 mA.
2. Connect a 3.3V supply to V_CTL 1–4. See Truth Table.
Unused V_CTL pins must be grounded or set to 0 V. Do not float
the connections.
3. Connect a 3 V supply to Tx EN. See Truth Table.
4. No connection to BIAS pin.
5. Connect a DVM to V_DET.
6. Connect a signal generator to the RF signal input port. Set it to
the desired RF frequency at a power level of -15 dBm or less
to the evaluation board, but do not enable the RF signal.
7. Connect a spectrum analyzer to the RF signal output port.
IMPORTANT: Terminate all unused ports in 50 Ω.
8. Enable the power supplies.
9. Enable the RF signal.
10. Take measurements.
CAUTION: If any of the input signals exceed the rated maximum
values, the SKY65206 Evaluation Board can be
permanently damaged.
Branding Specifications
Pin 1 Indicator
Skyworks Logo
Skyworks
Part No.
Vendor
Assembly
Number
SKY65206-13
Top View _{Date Code}
YY = Calendar Year
WW = Week
CC = Country
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
6
August 21, 2007 • Skyworks Proprietary Information • Products and Product Information are Subject to Change Without Notice. • 200102 Rev. H