SKY77324 Datasheet, PDF (11/24 Pages) Skyworks Solutions Inc. – iPAC PAM for Quad-Band GSM / GPRS

iPAC™ PAM FOR QUAD-BAND GSM / GPRS
DATA SHEET • SKY77324
Table 3. SKY77324 Electrical Specifications ⁽¹⁾ (9 of 9)
Parameter
Symbol
Test Condition
Time from POUT = –10 dBm to within
0.5 dBm of POUT = +1.5 dBm
Min.
Typ.
Max. Units
—
0.5
3.0
Open Loop⁽⁴⁾ Switching time
τRISE, τFALL
Time from POUT = –10 dBm to within
0.5 dBm of POUT = +20.0 dBm
—
0.8
1.1
µs
Time from POUT = –10 dBm to within
0.5 dBm of POUT = +32.0 dBm
—
1.2
1.5
Spurious
All combinations of the following parameters:
VAPC = controlled ⁽³⁾
Spur
PIN = min. to max.
No parasitic oscillation > –36 dBm
VCC = 2.9 V to 4.8 V
Load VSWR = 8:1, all phase angles
Load mismatch
All combinations of the following parameters:
VAPC = controlled ⁽³⁾
Load
PIN = min. to max.
No module damage or permanent degradation
VCC = 2.9 V to 4.8 V
Load VSWR = 10:1, all phase angles
Noise power
PNOISE
Power control dynamic range
PCDR
Power control variation ⁽⁵⁾
(Control level 0–8) 3.2 V ≤ VCC ≤ 4.5 V
PCV
Power control variation ⁽⁵⁾
(Control level 9–13)
PCV
Power control variation ⁽⁵⁾
(Control level 14–15)
PCV
Power control slope
PCS
Closed loop bandwidth
BCL
Loop phase margin
PM
At fO + 20 MHz
RBW = 100 kHz
VCC = 3.5 V
1.5 dBm ≤ POUT ≤ 32.0 dBm
TCASE = +25 °C
At 869 to 894 MHz
RBW = 100 kHz
VCC = 3.5 V
1.5 dBm ≤ POUT ≤ 32.0 dBm
TCASE = +25 °C
—
POUT +15.5 to +32.0 dBm, +25 °C
POUT +15.5 to +32.0 dBm
POUT +5.5 to +13.5 dBm, +25 °C
POUT +5.5 to +13.5 dBm
POUT +1.5 to +3.5 dBm, +25 °C
POUT +1.5 to +3.5 dBm
1.5 to 32.0 dBm
VAPC = 1.0 V
VAPC = 1.0 V
—
–82
–80
dBm
—
–97
–87
35
50
—
dB
–1.0
—
+1.0
dB
–1.6
—
+1.6
–1.8
—
+1.8
dB
–3.3
—
+3.3
–3.0
—
+3.0
dB
–4.5
—
+4.5
—
—
400
dB/V
—
500
—
kHz
75
—
—
deg.
(1) _{Unless specified otherwise:}
TCASE = –20 °C to maximum operating temperature (see Table 2)
RL = 50 Ω
pulsed operation with pulse width ≤ 1154 µs and duty cycle ≤ 2:8
Vcc = 2.9 V to 4.8 V.
(2) _{Icc = 0A to xA, where x = current at POUT = 34.5 dBm, 50 Ω load, and Vcc = 3.5 V.}
(3) _{Icc = 0A to xA, where x = current at POUT = 32.0 dBm, 50 Ω load, and Vcc = 3.5 V.}
(4) _{This device has an Open Loop mode that allows bypassing of the internal PAC circuitry. See the Technical Information section at end of this document for further information.}
(5) _{Power control variation is measured by comparing power obtained at a specified control voltage over all conditions, against the power obtained with the same control voltage at nominal}
conditions. For this module, nominal conditions are defined as
T = 25 °C
VCC = 3.5 V
PIN = 3 dBm
Frequency = mid-band
Skyworks Solutions, Inc. • Phone [781] 376-3000 • Fax [781] 376-3100 • [e-mail] • www.skyworksinc.com
103123C • Skyworks Proprietary and Confidential information. • Products and product information are subject to change without notice. • January 7, 2004
11