|
SP232A Datasheet, PDF (8/16 Pages) Sipex Corporation – Enhanced RS-232 Line Drivers/Receivers | |||
|
◁ |
SP310A transmitter and receiver outputs in a high
impedance condition (tri-stated). The shutdown
mode is controlled on the SP312A by a logic â0â
on the SHUTDOWN control line (pin 18); this also
puts the transmitter outputs in a triâstate mode.
The receiver outputs can be triâstated separately
during normal operation or shutdown by a logic
â1â on the ENABLE line (pin 1).
WakeâUp Feature for the SP312A
The SP312A has a wakeâup feature that keeps
all the receivers in an enabled state when the
device is in the shutdown mode. Table 1 defines
the truth table for the wakeâup function.
With only the receivers activated, the SP312A
typically draws less than 5µA supply current.
In the case of a modem interfaced to a computer
in power down mode, the Ring Indicator (RI)
signal from the modem would be used to "wake
up" the computer, allowing it to accept data
transmission.
After the ring indicator signal has propagated
through the SP312A receiver, it can be used to
trigger the power management circuitry of the
computer to power up the microprocessor, and
bring the SD pin of the SP312A to a logic high,
taking it out of the shutdown mode. The receiver
propagation delay is typically 1µs. The enable
time for V+ and Vâ is typically 2ms. After V+ and
Vâ have settled to their final values, a signal can
be sent back to the modem on the data terminal
ready (DTR) pin signifying that the computer is
ready to accept and transmit data.
Power
SD EN Up/Down
0
0
Down
0
1
Down
1
0
Up
1
1
Up
Receiver
Outputs
Enable
Triâstate
Enable
Triâstate
Table 1. Wake-up Function Truth Table.
Pin Strapping for the SP233ACT/ACP
The SP233A packaged in the 20âpin SOIC pack-
age (SP233ACT) has a slightly different pinout
than the SP233A in PDIP packaging (SP233ACP).
To operate properly, the following pairs of pins
must be externally wired together:
Pins Wired
Together
Two V- Pins
Two C2+ Pins
Two C2- Pins
SOIC PDIP
10 & 17 12 & 17
12 & 15 11 & 15
11 & 16 10 & 16
No Connections for
Pins 8, 13, and 14
Connect Pins 6 and 9
to GND
Jan 31-07 Rev B
SP232A/233A/310A/312A
© 2007 Sipex Corporation
|
▷ |