SP509_05 Datasheet, PDF (1/29 Pages) Sipex Corporation – Rugged 40Mbps, 8 Channel Multi-Protocol Transceiver with Programmable DCE/DTE and Termination Resistors

®
SP509
Rugged 40Mbps, 8 Channel Multi-Protocol Transceiver
with Programmable DCE/DTE and Termination Resistors
FEATURES
■ Ultra Fast 40Mbps Differential Transmission Rates Available
■ Improved ESD Tolerance for Analog I/Os with 15kV HBM.
■ Internal Transceiver Termination Resistors for V.11 and V.35
■ Interface Modes:
✓ RS-232 (V.28)
✓ X.21 (V.11)
✓ RS-449/V.36
(V.10 & V.11)
✓ EIA-530 (V.10 & V.11)
✓ EIA-530A (V.10 & V.11)
✓ V.35
Now Available in Lead Free Packaging
Refer to page 7 for pinout
■ Protocols are Software Selectable with 3-Bit Word
■ Eight (8) Drivers and Eight (8) Receivers
■ V.35 and V.11 Receiver Termination Network Disable Option APPLICATIONS
■ Internal Line or Digital Loopback for Diagnostic Testing
■ Router
■ Adheres to NET1/NET2 and TBR-2 Compliancy Requirements ■ Frame Relay
■ Easy Flow-Through Pinout
■ CSU
■ +5V Only Operation
■ DSU
■ Individual Driver and Receiver Enable/Disable Controls
■ PBX
■ Operates in either DTE or DCE Mode
■ Secure Communication Terminals
DESCRIPTION
The SP509 is a monolithic device that supports eight (8) popular serial interface standards for
Wide Area Network (WAN) connectivity. The SP509 is fabricated using a low power BiCMOS
process technology, and incorporates a Sipex regulated charge pump allowing +5V only
operation. Sipex's patented charge pump provides a regulated output of +5.8V, which will
provide enough voltage for compliant operation in all modes. Eight (8) drivers and eight (8)
receivers can be configured via software for any of the above interface modes at any time. The
SP509 requires no additional external components for compliant operation for all of the eight
(8) modes of operation other than four capacitors used for the internal charge pump. All
necessary termination is integrated within the SP509 and is switchable when V.35 drivers and
V.35 receivers, or when V.11 receivers are used. The SP509 provides the controls and
transceiver availability for operating as either a DTE or DCE.
Additional features with the SP509 include internal loopback that can be initiated in any of the
operating modes by use of the LOOPBACK pin. While in loopback mode, receiver outputs are
internally connected to driver inputs creating an internal signal path bypassing the serial
communications controller for diagnostic testing. The SP509 also includes a latch enable pin
with the driver and receiver address decoder. The internal V.11 or V.35 receiver termination
can be switched off using a control pin (TERM_OFF) for monitoring applications. All eight (8)
drivers and receivers in the SP509 include separate enable pins for added convenience. The
SP509 is ideal for WAN serial ports in networking equipment such as routers, concentrators,
network muxes, DSU/CSU's, networking test equipment, and other access devices.
Applicable U.S. Patents-5,306,954; and others patents pending
Date: 1/19/05
SP509 Enhanced WAN Multi–Protocol Serial Transceiver
1
© Copyright 2005 Sipex Corporation