SII0680A Datasheet, PDF (101/124 Pages) Silicon image – PCI to IDE/ATA

Silicon Image, Inc.
SiI0680A PCI to IDE/ATA
Data Sheet
• Bit [11:09]: Device 0 HSTROBE Delay (R/W) – IDE1 Device 0 HSTROBE Delay for UDMA Mode. This bit field
is used for programming the HSTROBE output delay in increments of 2 nsec in UDMA mode
• Bit [08:07]: Reserved (R). This bit field is reserved and returns zeros on a read.
• Bit [22]: Reserved (R/W) – This bit field is reserved.
• Bit [05:00]: Device 0 Cycle Time Count (R/W) – IDE1 Device 0 UDMA Cycle Time Count. This bit field is used
for programming the UDMA Active and Recovery Time.
9.7.51 Test Register – IDE1
Address Offset: F0_H
Access Type: Read/Write
Reset Value: 0x0000_0000
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 09 08 07 06 05 04 03 02 01 00
Module Select Nibble Select
Sub-Module Select
Data Field
This register defines the test register for IDE Channel #1 in the SiI 0680A. This register is for chip-level simulation and
verification purposes only. The register bits are defined below.
• Bit [31:28]: Module Select (R/W) – IDE1 Test Module Select. This bit field is used to select the logic module for
testing: 0001_B = DIF module; 0010_B = TMR module; 0011_B = PIF module; and, 0100_B = DUW module.
• Bit [27:24]: Nibble Select (R/W) – IDE1 Test Control Nibble Select. This bit field is used to select the control
nibble for testing. A value of 0001_B selects the least significant nibble, while a value of 1000_B selects the most
significant nibble.
• Bit [23:16]: Sub-Module Select (R/W) – IDE1 Test Sub-Module Select. This bit field is used to select the logic
sub-module for testing. The valid selections are listed below.
Module Select
0001_B
0010_B
0010_B
0010_B
0010_B
0011_B
0011_B
0100_B
Sub-Module Select
0001_B
0001_B
0010_B
0011_B
0100_B
0001_B
0010_B
0001_B
Description
FIFO Data
Timer 1
Timer 2
Timer 3
Timer 4
PBM_BYTE_CNT
WD_TMO
DUW_TMR_CNT
Table 9-11: IDE1 Test Register Selections
• Bit [15:00]: Data Field (R/W) – IDE1 Test Data Field. This bit field is used to write a preload value to the
selected counter or read the current value of the selected counter.
© 2006 Silicon Image, Inc.
101
SiI-DS-0069-C