EFM32GG232 Datasheet, PDF (62/71 Pages) Silicon Laboratories – High Performance 32-bit processor

7 Revision History
...the world's most energy friendly microcontrollers
7.1 Revision 1.40
March 21st, 2016
Added clarification on conditions for INL_ADC and DNL_ADC parameters.
Reduced maximum and typical current consumption for all EM0 entries except 48 MHz in the Current
Consumption table in the Electrical Characteristics section.
Increased maximum specifications for EM2 current, EM3 current, and EM4 current in the Current Con-
sumption table in the Electrical Characteristics section.
Increased typical specification for EM2 and EM3 current at 85 C in the Current Consumption table in
the Electrical Characteristics section.
Added EM2, EM3, and EM4 current consumption vs. temperature graphs.
Added a new EM2 entry and specified the existing specification is for EM0 for the BOD threshold on
falling external supply voltage in the Power Management table in the Electrical Characteristics section.
Reduced maximum input leakage current in the GPIO table in the Electrical Characteristics section.
Added a maximum current consumption specification to the LFRCO table in the Electrical Characteristics
section.
Added maximum specifications for the active current including references for two channels to the DAC
table in the Electrical Characteristics section.
Increased the maximum specification for DAC offset voltage in the DAC table in the Electrical Charac-
teristics section.
Increased the typical specifications for active current with FULLBIAS=1 and capacitive sense internal
resistance in the ACMP table in the Electrical Characteristics section.
Added minimum and maximum specifications and updated the typical value for the VCMP offset voltage
in the VCMP table in the Electrical Characteristics section.
Removed the maximum specification and reduced the typical value for hysteresis in the VCMP table in
the Electrical Characteristics section.
Updated all graphs in the Electrical Characteristics section to display data for 2.0 V as the minimum
voltage.
7.2 Revision 1.30
May 23rd, 2014
Removed "preliminary" markings
Updated HFRCO figures.
Corrected single power supply voltage minimum value from 1.85V to 1.98V.
Updated Current Consumption information.
Updated Power Management information.
2016-03-21 - EFM32GG232FXX - d0125_Rev1.40
62
www.silabs.com