EFM32G290 Datasheet, PDF (61/72 Pages) Silicon Laboratories – Wake-up Interrupt Controller

7 Revision History
...the world's most energy friendly microcontrollers
7.1 Revision 1.90
May 22nd, 2015
Added clarification on conditions for INL_ADC and DNL_ADC parameters.
Corrected EM2 current consumption condition in Electrical Characteristics section.
Added AUXHFRCO to block diagram and Electrical Characteristics.
Updated HFRCO table in the Electrical Characteristics section.
Updated EM0, EM2, EM3, and EM4 maximum current specifications in the Electrical Characteristics
section.
Updated the Output Low Voltage maximum for sinking 20 mA with VDD = 3.0 V in the Electrical Char-
acteristics section.
Updated the Input Leakage Current maximum in the Electrical Characteristics section.
Updated the minimum and maximum frequency specifications for the LFRCO, HFRCO, and AUXHFRCO
in the Electrical Characteristics section.
Updated the maximum current consumption of the HFRCO in the Electrical Characteristics section.
Updated the maximum current consumption of the HFRCO in the Electrical Characteristics section.
Added some minimum ADC SNR, SNDR, and SFDR specifications in the Electrical Characteristics sec-
tion.
Added some minimum and maximum ADC offset voltage, DNL, and INL specifications in the Electrical
Characteristics section.
Added maximum DAC current specifications in the Electrical Characteristics section.
Added maximum ACMP current and maximum and minimum offset voltage specifications in the Electrical
Characteristics section.
Added maximum VCMP current and updated typical VCMP current specifications in the Electrical Char-
acteristics section.
Updated references to energyAware Designer to Configurator.
7.2 Revision 1.80
July 2nd, 2014
Corrected single power supply voltage minimum value from 1.85V to 1.98V.
Updated current consumption.
Updated transition between energy modes.
Updated power management data.
Updated GPIO data.
2015-05-22 - EFM32G290FXX - d0007_Rev1.90
61
www.silabs.com