SI500S Datasheet, PDF (4/6 Pages) Silicon Laboratories – Quartz-free, MEMS-free, and pll-free all-silicon oscillator Any output frequencies from 0.9 to 200 MHz

Si500S
Environmental Compliance
Parameter
Mechanical Shock
Mechanical Vibration
Resistance to Soldering Heat
Solderability
Damp Heat
Moisture Sensitivity Level
Conditions/Test Method
MIL-STD-883, Method 2002.4
MIL-STD-883, Method 2007.3 A
MIL-STD-202, 260 C° for 8 seconds
MIL-STD-883, Method 2003.8
IEC 68-2-3
J-STD-020, MSL 3
Ordering Information
The Si500S supports a variety of options including frequency, output format, supply voltage, and tri-
state/powerdown/output driver stopped mode. Specific device configurations are programmed into the Si500S at
time of shipment. Configurations are specified using the figure below. Silicon Labs provides a web-based part
number utility that can be used to simplify part number configuration. Refer to
www.silabs.com/SiliconXOPartnumber to access this tool. The Si500S silicon oscillator is supplied in a ROHS-
compliant, 4-pad, 3.2 x 4.0 mm package. Tape and reel packaging is available as an ordering option.
500S
X
X
X
XXMXXXX
A
C
X
R
Si500 Oscillator
1^st Option Code
V_DD
A 3.3
D 3.3
E 2.5
H 2.5
J 1.8
M 1.8
Format
CMOS
SSTL
CMOS
SSTL
CMOS
SSTL
Frequency
xMxxxxx: f_OUT < 10 MHz
xxMxxxx: 10 MHz < f_OUT < 100 MHz
xxxMxxx: fOUT > 100 MHz
3^rd Option Code
Tri-State/Powerdown/
Output Driver Stopped
A
OE active high/tristate
B
OE active low/tristate
C
OE active high/powerdown
D
OE active low/powerdown
E
OE active high/driver stopped
F
OE active low/driver stopped
2^nd Option Code
Stability (ppm, max)
A
±150
B
±250
R = Tape & Reel
Blank = Cut-Tape
Oper. Temp Range
F
0 to 70 °C
*H
0 to 85 °C
Product Revision = C
Package
A
3.2 x 4.0 mm SMD
*Note: Only +250 ppm is supported.
4
Rev. 1.1