|
EZRADIOPRO-DK Datasheet, PDF (4/17 Pages) – | |||
|
◁ |
EZRadioPRO-DK
Figure 2. WDS Application Manager Window
Repeat steps 1 to 9 for the other node of the kit.
The two nodes are now ready for evaluation. Detailed descriptions of the example codes can be found in the
programming guide listed in "4. Useful Documentation" on page 5.
The following is a quick-step guide to performing simple packet TX/RX.
1. Leave both nodes powered from the USB as described above.
2. Select âRadio Configuration Applicationâ.
3. From the Radio Configuration Application window, select âStandard Packet TXâ for one node and âStandard
Packet RXâ for the other node.
4. 4Leave the default parameter settings untouched; simply click âDownload projectâ.
5. Now, the simple TX/RX sample project is running on the boards. When pressing one of the SW1 to SW4
buttons on the TX board, packets are sent, and the corresponding LED of LED1 to LED4 lights up during
the transmission. On the RX side, LED1 is always on, while different combinations of LED2 to LED4 light
up during successful packet reception according to the button pressed.
4
Rev. 0.5
|
▷ |