SI7013EVB-UDP-M3L1 Datasheet, PDF (15/26 Pages) Silicon Laboratories – Si7013EVB-UDP-M3L1 Users Guide

Si7013EVB-UDP-M3L1
4.7.2.1. Using the Data Logger Application
The Data Logger application runs on a PC and is used to configure the Data Logger firmware. The Data Logger
application can also display the log data.
To run the Data Logger application from the Start menu, select Start  Silicon Laboratories  Si70xx Data Logger.
This opens up the Data Logger application shown in Figure 10.
Figure 10. Data Logger Application
The left side of the application window is used to configure the Data Logger firmware. The right side of the
application window is used to display log data.
4.7.2.1.1. Data Logger Status
The Data Logger Status box shown in Figure 11 displays the status of the Data Logger firmware.
Figure 11. Data Logger Status Box
If there are no alarms or errors, this box displays “OK”. If there is an alarm, this box displays an alarm message. If
the status is “Communications Error”, this means the MCU card cannot communicate with the Si7005 port header
card.
Rev. 0.2
15