English
Language : 

SI88X4X Datasheet, PDF (10/48 Pages) Silicon Laboratories – Precise timing on digital isolators
Si88x4x
Table 2. Electrical Characteristics1 (Continued)
VIN = 24 V; VDDA = 4.3 V (see Figure 3) for all Si8844x/64x; VDDA = VDDP = 3.0 to 5.5 V (see Figure 2) for all Si8824x/34x;
TA = –40 to 125 °C unless otherwise noted
Parameter
Symbol
Test Condition
Min Typ Max Unit
Si88x41
mA
VDDA
VDDB
—
8.4
—
—
6.3
—
Si88x42
mA
VDDA
VDDB
—
8.2
—
—
6.2
—
Si88x43
mA
VDDA
VDDB
—
7.8
—
—
6.7
—
Si88x44
mA
VDDA
VDDB
—
6.9
—
—
7.4
—
100 Mbps, VDDx = 5 V ± 10% (All Inputs = 50 MHz Square Wave, CLOAD = 15 pF)
Si88x40
VDDA
VDDB
Si88x41
VDDA
VDDB
Si88x42
VDDA
VDDB
Si88x43
VDDA
VDDB
Si88x44
VDDA
VDDB
Timing Characteristics
mA
—
8.2
—
— 26.2 —
mA
— 14.7 —
— 22.0 —
mA
— 18.9 —
— 16.5 —
mA
— 24.0 —
— 11.7 —
mA
— 28.1 —
—
6.6
—
Data Rate
0
— 100 Mbps
Notes:
1. Over recommended operating conditions as noted in Table 1.
2. VOUT = VSNS x (1 + R1/R2) + R1 x Ioffset
3. VDDP current needed for dc-dc circuits.
4. VDDA current needed for dc-dc circuits.
5. The nominal output impedance of an isolator driver channel is approximately 50 , ±40%, which is a combination of the
value of the on-chip series termination resistor and channel resistance of the output driver FET. When driving loads
where transmission line effects will be a factor, output pins should be appropriately terminated with controlled
impedance PCB traces.
6. tPSK(P-P) is the magnitude of the difference in propagation delay times measured between different units operating at
the same supply voltages, load, and ambient temperature.
7. Start-up time is the time period from when the UVLO threshold is exceeded to valid data at the output.
10
Preliminary Rev. 0.6