EZR32WG-490MHZ Datasheet, PDF (10/29 Pages) Silicon Laboratories – Advanced Energy Monitoring

EZR32WG 490MHz Wireless Starter Kit
Peripherals
5.2 Memory LCD-TFT Display
A 1.28-inch SHARP Memory LCD-TFT has been added to the board to enable interactive applications to be developed. The display has
a high resolution of 128 by 128 pixels, and consumes very little power. It is a reflective monochrome display, so each pixel can only be
light or dark, and no backlight is needed in normal daylight conditions.
The display interface consists of an SPI-compatible serial interface and some extra control signals. Data is sent to the display one line
(128 bits) at a time.
The Memory LCD-TFT display is shared with the kit Board Controller, allowing the Board Controller application to display useful infor-
mation when the user application is not using the display. The user application always controls ownership of the display with
EFM_DISP_SELECT (PA8):
• 0: The Board Controller has control of the display
• 1: The user application (EZR32) has control of the display
EFM_DISP_PWR (PA10) enables power to the display, and must be set high in order to use the display. Data is clocked in on
EFM_DISP_MOSI (PD7) when EFM_DISP_CS (PE11) is high, and the clock is sent on EFM_DISP_SCLK (PC15). The maximum sup-
ported clock speed is 1.1 MHz.
EFM_DISP_COM (PE10) is the "COM Inversion" line. It must be pulsed periodically to prevent static build-up in the display itself.
Please refer to the display application information for details on driving the display:
http://www.sharpmemorylcd.com/1-28-inch-memory-lcd.html
Figure 5.2. 128x128 pixel Memory LCD
5.3 Backup Domain Capacitor
A small super capacitor is provided to evaluate the EZR32 Wonder Gecko MCU's backup power domain. The capacitor has a nominal
value of 33 mF, and is connected with a 100 ohm series resistor to the BU_VIN pin of the EZR32.
Because of the extremely low power consumption of the EZR32 in backup mode (400nA), the capacitor can power a clock application
using the low frequency crystal oscillator (LFXO) for more than 8 hours.
The series resistor allows measuring of the current drawn from the capacitor into the EZR32 device, by simply using a multimeter to
measure the voltage across it. Please refer to the schematic and assembly drawings to locate the series resistor.
silabs.com | Smart. Connected. Energy-friendly.
Rev. 1.2 | 7