S-24CS16A0I-T8T1G Datasheet, PDF (23/46 Pages) Seiko Instruments Inc – 2-WIRE CMOS SERIAL E2PROM

Rev.5.2_00
2-WIRE CMOS SERIAL E²PROM
S-24CS16A
5.0
4.0
Power supply voltage (V_CC)
[V]
3.0
2.0
50 100 150 200
Rise time (t_RISE) Max.
[ms]
For example: If your E²PROM supply voltage = 5.0 V, raise the power supply voltage to 5.0 V within 200 ms.
Figure 28 Raising Time of Power Supply Voltage
When initialization is successfully completed via the power-on-clear circuit, the E²PROM enters the standby status.
If the power-on-clear circuit does not operate, the following are the possible causes.
(1) Because the E²PROM has not been initialized, an instruction formerly input is valid or an instruction may be
inappropriately recognized. In this case, writing may be performed.
(2) The voltage may have dropped due to power off while the E²PROM is being accessed. Even if the microprocessor
is reset due to the low power voltage, the E²PROM may malfunction unless the power-on-clear operation conditions
of E²PROM are satisfied. For the power-on-clear operation conditions of E²PROM, refer to 5.1 Raising power
supply voltage.
If the power-on-clear circuit does not operate, match the phase (reset) so that the internal E²PROM circuit is normally
reset. The statuses of the E²PROM immediately after the power-on-clear circuit operates and when phase is matched
(reset) are the same.
Seiko Instruments Inc.
23