SLX24C164P Datasheet, PDF (5/27 Pages) Siemens Semiconductor Group – 16 Kbit 2048 x 8 bit Serial CMOS EEPROMs, I2C Synchronous 2-Wire Bus, Page Protection Mode

SLx 24C164/P
Pin Description
Serial Clock (SCL)
The SCL input is used to clock data into the device on the rising edge and to clock data
out of the device on the falling edge.
Serial Data (SDA)
SDA is a bidirectional pin used to transfer addresses, data or control information into the
device or to transfer data out of the device. The output is open drain, performing a wired
AND function with any number of other open drain or open collector devices. The SDA
bus requires a pull-up resistor to V_CC.
Chip Select (CS0, CS1, CS2)
The CS0, CS1 and CS2 pins are chip select inputs either hard wired or actively driven
to V_CC or V_SS. These inputs allow the selection of one of eight possible devices sharing
a common bus.
Write Protection (WP)
WP switched to V_SS allows normal read/write operations.
WP switched to V_CC protects the entire EEPROM against changes (hardware write
protection).
Additionally write protection is managed by a protection bit associated to each page.
(refer to chapter 7 Page Protection Mode^TM)
Semiconductor Group
5
1998-07-27