C4P-SA21010A001000 Datasheet, PDF (3/10 Pages) SICK AG – SAFETY LIGHT CURTAINS

C4P-SA21010A001000, C4P-EA21010A001000 | deTec4 Prime
SAFETY LIGHT CURTAINS
Functions
Functions
Restart interlock
✔
External device monitoring (EDM)
✔
Beam coding
✔
Automatic calibration of the protective field ✔
width
Interfaces
Delivery status
Deactivated
Deactivated
Uncoded
System connection
Connection type Male connector M12, 5-pin
Flexi-Loop-ready ✔
Sender/receiver communication (COM1) _✔ ¹⁾
Permitted cable length _{Receiver power supply: 15 m} ²⁾
All additional conductors at the system connection: 37.5 m
Configuration method
Cascade Automatic detection when starting the device
External device monitoring (EDM) Automatic detection when starting the device
Calibration of the protective field width Automatic detection when starting the device
Restart interlock Teach-in procedure when starting the device
Beam coding DIP switch
Reset to factory default DIP switch
Status display
LEDs
Fieldbus, industrial network
Integration via Flexi Soft safety controller _{CANopen, DeviceNet™, EtherCAT®, EtherNet/IP™, Modbus TCP, PROFIBUS DP, PROFINET} ³⁾
1) _{Optional: To indicate the status on both sides, the COM1 connections from the sender and receiver must be connected to each other in the control cabinet.}
2) _{If no inductive OSSD loads (e.g., contactors) are in use, the power supply cable for the receiver of a single device (no cascade) can be up to 30 m in length.}
3) _{For additional information on Flexi Soft -> www.sick.com/Flexi_Soft.}
Electrical data
Protection class
III (EN 50178) ¹⁾
Supply voltage V_S
24 V DC (19.2 V DC ... 28.8 V DC)
Ripple
≤ 10 % ²⁾
Power consumption typical
5.41 W (DC) / 2.46 W (DC) (depending on type)
Safety outputs (OSSD)
Type of output _{2 PNP semiconductors, short-circuit protected, cross-circuit monitored} ³⁾
Switching voltage HIGH 24 V DC (V_S – 2.25 V DC ... V_S)
Switching voltage LOW ≤ 2 V DC
Switching current ≤ 500 mA
1) _{SELV/PELV safety/protective extra-low voltage.}
2) _{Within the limits of VS.}
3) _{Applies to the voltage range between –30 V and +30 V.}
2017-08-21 16:38:06 | Online data sheet
S ubject to change without notice
OPTO-ELECTRONIC PROTECTIVE DEVICES | SICK
3