PR33MF51NSZF Datasheet, PDF (8/14 Pages) Sharp Electrionic Components – Non-Zero Cross type DIP 8pin Triac output SSR

PR33MF51NSZF Series
■ Design Considerations
● Recommended Operating Conditions
Parameter
Symbol
Condition
MIN. MAX. Unit
Input ^{Input signal current at ON state IF(ON)}
−
20
25
mA
Input signal current at OFF state I_F(OFF)
−
0
0.1
mA
Load supply voltage
V_OUT(rms)
−
−
240
V
Output Load supply current
Locate snubber circuit between output terminals
I_OUT(rms)
(Cs=0.022μF, Rs=47Ω)
−
I_T(rms)×
80%(*)
A
Frequency
f
−
50
60
Hz
Operating temperature
T_opr
−
−20
80
˚C
(*) See Fig.2 about derating curve (IT(rms) vs. ambient temperature).
● Degradation
In order for the SSR to turn off, the triggering current (I_F) must be 0.1mA or less
In phase control applications or where the SSR is being by a pulse signal, please ensure that the pulse width
is a minimum of 1ms.
When the input current (I_F) is below 0.1mA, the output Triac will be in the open circuit mode. However, if the
voltage across the Triac, V_D, increases faster than rated dV/dt, the Triac may turn on. To avoid this situa-
tion, please incorporate a snubber circuit. Due to the many different types of load that can be driven, we can
merely recommend some circuit values to start with : Cs=0.022μF and Rs=47Ω. The operation of the SSR
and snubber circuit should be tested and if unintentional switching occurs, please adjust the snubber circuit
component values accordingly
When making the transition from On to Off state, a snubber circuit should be used ensure that sudden drops
in current are not accompanied by large instantaneous changes in voltage across the Triac.
This fast change in voltage is brought about by the phase difference between current and voltage.
Primarily, this is experienced in driving loads which are inductive such as motors and solenods.
Following the procedure outlined above should provide sufficient results.
Any snubber or Varistor used for the above mentioned scenarios should be located as close to the main out-
put triac as possible.
All pins shall be used by soldering on the board. (Socket and others shall not be used.)
● Degradation
In general, the emission of the IRED used in SSR will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these SSRs should provide at least
twice the minimum required triggering current from initial operation.
Sheet No.: D4-A03901EN
8