LQ035Q7DH01 Datasheet, PDF (8/24 Pages) Sharp Electrionic Components – TFT-LCD Module

(7)Electrical characteristics
7-1)Recommended operating conditions
A) TFT-LCD panel driving section
Table 6
GND=0V
Parameter
Symbol Min.
Typ.
Max. Unit Remarks
Supply voltage for source driver
VSHA +4.5
+5.0
+5.5
V
(Analog)
Supply voltage for source driver
VSHD +3.0
+3.3
+3.6
V
(Digital)
Supply voltage High voltage
VDD +14.5
+15.0
+15.5 V
for gate driver
Low voltage
VEE
-10.5
-10.0
-9.5
V
Input voltage for Source driver (Low) VILS GND
-
0.2VSHD V Note 7-1
Input voltage for Source driver (High) VIHS 0.8VSHD
-
VSHD V Note 7-1
Input current for Source driver (Low) IILS
-
-
30
A Note 7-1
IIHS1
-
Input current for Source driver (High)
IIHS2
-
-
30
A Note 7-2
-
1200
A Note 7-3
Input voltage for Gate driver (Low) VILG GND
-
0.2VSHD V Note 7-4
Input voltage for Gate driver (High) VIHG 0.8VSHD
-
VSHD V Note 7-4
Input current for Gate driver (Low)
IILG
-
-
4
A Note 7-4
Input current for Gate driver (High) IIHG
-
-
4
A Note 7-4
Common electrode AC component VCOMAC -
2.5
2.6 Vp-p Note 7-5
driving signal
DC component VCOMDC 0.8
+0.2
+1.2
V Note 7-5
Cautions when you turn on or off the power supply
Turn on or off the power supply with simultaneously or the following sequence.
The input signal of “MOD” Terminals(Pin No.11) must be low voltage when turning on the power
supply, and it is held until more than double vertical periods after DATA is turned on completely.
After then, it must be held high voltage until turning off the power supply.(Connect Pin No.11
terminals to the same signal.)