GP1U26R Datasheet, PDF (3/5 Pages) Sharp Electrionic Components – Anti Electromagnetic Induction Noise Type Compact IR Detecting Unit for Remote Control

GP1U26R/27R/28R/28Q Series
s Electrical Characteristics
Parameter
Dissipation current
High level output voltage
Low level output voltage
High level pulse width
Low level pulse width
B.P.F. center frequency
Symbol
ICC
V OH
V OL
T1
T2
fO
Conditions
No input light
*3
-
MIN.
-
VCC - 0.5
-
400
400
-
(Ta=25˚C, V_CC =+5V)
TYP. MAX. Unit
-
5.0
mA
-
-
V
-
0.45
V
-
800
µs
-
800
*4
-
kHz
*3 The burst wave as shown in the following figure shall be transmitted by the transmitter shown in Fig. 1.
The carrier frequency of the transmitter, however, shall be same as *4, and measurement shall be taken of the 100th and subsequent pulses after start of transmission.
*4 The B.P.F. center frequency fo varies with model, as shown in s Model Line-ups .
Burst wave
600µ s
600µ s
fO = *4 kHz Duty 50%
s Performance
Using the transmitter shown in Fig. 1, the output signal of the light detecting unit is good enough to meet the following items in the standard optical system in Fig. 2.
(1) Linear reception distance characteristics
When L=0.2 to 6.5 m, Ee^*5< 10 lx and φ =0˚ in Fig. 2, the output signal shall meet the electrical characteristics in the attached list.
(2) Sensitivity angle reception distance characteristics
When L=0.2 to 4.5 m, Ee^*5< 10 lx and φ<= 30 ˚ in Fig. 2, the output signal shall meet the electrical characteristics in the attached list.
(3) Anti outer peripheral light reception distance characteristics
When L=0.2 to 3 m, Ee^*6<= 300 lx and φ =0˚ in Fig. 2, the output signal shall meet the electrical characteristics in the attached list.
*5 It refers to detector face illuminance.
*6 Outer peripheral light source : CIE standard light source A shall be used and placed at 45 ˚ from perpendicular axis at the detector face center.
20cm
10kΩ
+ 5V
Transmitter (GL521 used)
f_O= *4
Duty 50%
Vout
Oscilloscope
In the above figure, the transmitter should be set so that the output Vout can be 40mV P - P.
However, the PD49PI to be used here should be of the short-circuit current ISC =2.6 µ A at EV=100 lx.
(EV is an illuminance by CIE standard light source A (tungsten lamp).)
Fig. 1 Transmitter