GP1A75E Datasheet, PDF (3/3 Pages) Sharp Electrionic Components – Small Size OPIC Photointerrupter with Connector

Fig. 5 Detecting Position Characteristics (1)
V_CC = 5V,T _a= 25˚C
Detecting position
d= 2.35± 0.3mm ^{Output High}
0d
GP1A75E
Fig. 6 Detecting Position Characteristics (2)
V_CC = 5V
T_a= 25˚C
Detecting position
h= 3.0± 1.0mm
Output High
0
Output Low
0
1
2
3
4
5
Shield distance d ( mm )
s Recommended Mounting Holes (Unit : mm )
Output Low
0
1
2
3
4
5
Shield distance h ( mm )
3.2
φ
8.2
Mounting method
s Precautions for Use
( 1) In this product, the PWB is fixed with a hook, and cleaning solvent may remain inside
the case; therefore, dip cleaning or ultrasonic cleaning are prohibited.
( 2) Remove dust or stains, using an air blower or a soft cloth moistened in cleaning solvent.
In this case, use only the following type of cleaning solvent used for wiping off:
Ethyl alcohol, Methyl alcohol, Isopropyl alcohol
When the cleaning solvents except for specified materials are used, please consult us.
( 3) In order to stabilize power supply line, connect a by-pass capacitor of more than 0.01µF
between Vcc and GND near the device.
( 4) As for other general cautions, refer to the chapter“ Precautions for Use”.